3003 W CASINO RD BASE FILE 2023-10-24

SIEMENS Data Sheet Fire Safety & Security Products Peripheral Devices Intelligent Control Point Device Model HCP ARCHITECT AND ENGINEER SPECIFICATIONS • Intelligent device for use with various Siemens — Fire Safety fire -alarm control panels (FACPs) • Used as a telephone zone, speaker zone or notification appliance circuit (NAC) • Provides 24VDC NACs when used with a Siemens FACP • Used as a NAC under the Siemens — Fire Safety NAC product line • Provides either a 25V (35 Watts) or 70.7V (25 Watts) single -channel speaker zone (used with Siemens' XLS FRCP only) • Provides firefighters' telephone circuit (used with Siemens' XLS FACP only) • Polarity insensitive with SureWireTM technology • Mounts on standard electrical box • 4" square or double gang • No mechanical -address programming required • Includes a dial -tone generator for telephone usage Product Overview Model HCP from Siemens — Fire Safety is an intelligent control point device designed for use with various Siemens — Fire Safety FACPs, as well as with the Siemens — Fire's NAC series of alarm signaling devices. Model HCP can be configured as an independent, remotely located telephone zone, speaker zone or NAC. Model HCP is programmed and tested using the Device Programming I Test Unit (Model DPU), which eliminates the need for mechanical -addressing mechanisms (i.e. — program jumpers, DIP switches or rotary dials). Model HCP is supervised for loss of 24VDC input power, as well as short -or -open output -zone wiring. Model HCP mounts in a standard double -gang or 4" square electrical box. When Model HCP is programmed as a speaker zone, the high -power audio risers are supervised using the Model ZAC-40 zone amplifiers. Programmed as a telephone zone, the telephone riser is supervised by the (8) Eight -Zone Telephone Card (Model TZC-8). Note: Telephone application is not approved for use in Canada. • Supervised input and output power • (WL Listed, oULC Listed; CSFM and NYC Fire Dept. Approved Specifications Model HCP communicates through the analog loop of Models DLC and FS-DLC, and can be wired either Class A (Style Z) or Class B (Style Y). The 24 VDC power input comes from either the FACP or from any oUL Listed power -limited, auxiliary power supply. For FireFinder XLS systems, compatible power supplies for the intelligent control point device are: • Model PSC-12 • Model PSX-12 • Model PAD-3, or • Any power -limited, 24 VDC power supply that is OUL Listed for fire -protective signaling use For MPC 1 FS-250 line of FACPs, compatible power supplies are as follows: • Siemens NAC circuits • Model PAD-3, or • Any power -limited, 24 VDC power supply that is OUL Listed for fire -protective -signaling use Up to 60 Model HCP devices can be wired to a given loop on a FireFinder XLS or FS-250 panel. Note: The maximum NAC load that may be connected to a Model HCP device is 1.5 Amps at 24VDC. Intelligent Control Point Device 631 1 SIEMENS Industry, Inc. Building Technologies Division