Laserfiche WebLink
VERETT <br />0 <br />Permit Inspections <br />City of Everett <br />9/21/2023 <br />9/21/2023 <br />PLUMB 08-FINAL** <br />JASON <br />CORRECTION <br />see notes <br />MORRISSEY <br />REQUIRED <br />Notes: <br />9/15/2023 8:48 AM William Hatfield <br />Contact Name: William Hatfield <br />Site Address: 1321 SE EVERETT MALL WAY STE C <br />Phone:4253615313 <br />e-Mail: bhatfield@cpmnw.com <br />jjm changed Inspection Type from PLUMB 05-COMM KITCHEN PREOP INSPECTION to PLUMB 08-FINAL** <br />- Install trap primer for hub drain next crab tank per the UPC 1007.1 - Install trap on 2" indirect drain from pre rinse due to length over 5' per the UPC <br />803.3 Pipe Size and Length- Install trap for three compartment sink so it is plumbed off the center basin outlet per the UPC 1001.2 Where Required - <br />Install ridged PVC 3/4" pipe for indirect drains on ice bins on soda machine with a 1" air gap to floor sinks per the UPC- (bar area) Run washboard <br />indirect drain separately to floor sink with air gap per the UPC 801.3.3 Food -Handling Fixtures cannot tie indirect drains for food or beverage fixtures <br />together must run separate.- (bar area) Attach all plumbing fixtures to wall to prevent stress on plumbing system.- (bar area) Repair leaking hand wash <br />sink on bar area.*** Install commercial dishwasher for final. If it's chemical injection type it will require an RPBA on the water supply inlet to the fixture <br />per the UPC chap 6. If the discharge water temperature is above 140 a tempering valve will be required to lower the discharge water temp to below 140 <br />to protect the drainage system. <br />9/22/2023 <br />9/22/2023 <br />PLUMB 08-FINAL <br />JASON <br />NOT READY <br />eTRAKiT Inspection Request <br />MORRISSEY <br />Notes: <br />9/15/2023 8:48 AM William Hatfield <br />Contact Name: William Hatfield <br />Site Address: 1321 SE EVERETT MALL WAY STE C <br />Phone:4253615313 <br />e-Mail: bhatfield@cpmnw.com <br />- Not ready. Contractor to reschedule when ready. <br />10/12/2023 <br />10/12/2023 <br />PLUMB 08-FINAL** <br />JEFF M RHODE <br />CORRECTION <br />see notes <br />REQUIRED <br />Notes: <br />10/10/2023 7:54 AM William Hatfield <br />Contact Name: William Hatfield <br />Site Address: 1321 SE EVERETT MALL WAY STE C <br />Phone:4253615313 <br />e-Mail: bhatfield@cpmnw.com <br />-provide back flow prevention on dishwasher per upc 603.5.6.3 -provide installation instructions for dishwasher to verify discharge temperature -all <br />other corrections made listed on previous inspection <br />I <br />Printed: Wednesday, 18 October, 2023 4 of 5 rk <br />SUPERION <br />