5611 COLBY AVE 2024-02-09 - Laserfiche WebLink

Two-Hole Strap-designed to support CPVC piping systems when attached to a flat, horizontal surface with the screw-type fasteners in the vertical position. In addition, the two-hole strap is designed to support CPVC piping systems when attached to a flat, vertical surface with one mounting tab in the vertical position and the screw-type fasteners in the horizontal position.The two-hole strap can be used as a piping system guide when the system lies on tap of a beam, and the beam supports the system's weight. Two-Hole 90°Side Mount Strap-designed to support CPVC piping systems when attached to a horizontal beam with the screw-type fasteners in the horizontal position and the pipe hanging below the beam. The fastener's mounting edges are designed to allow the screws to be installed horizontally. This is a benefit when overhead clearance is limited. In addition,the 900 side mount strap can be used in a restrainer fashion when it is attached to the top of a beam, and the system lies on top of the beam. flis r Supports Risers must be supported by pipe clamps or by hangers located on the horizontal connection close to the riser. Only Listed hangers and clamps can be used. Vertical lines must be supported at intervals to avoid placing excessive load on a fitting at the lower end. This can be done by using riser clamps or double-bolt pipe clamps listed for this service. Hangers and supports must not compress, distort, cut, or abrade the piping, and they must allow free movement of the pipe for thermal expansion and contraction. DO NOT use riser clamps that squeeze the pipe and depend on compression of the pipe to support the weight. Maintain vertical piping in straight alignment with supports at each floor level or 10-foot intervals,whichever is less. CPVC risers in vertical shafts or buildings with ceilings over 25 feet must be aligned straight and supported at each floor level or 10-foot intervals,whichever is less. G-3-1010 O 2010 SpearsO Manufacturing Company Page 41