1605 SE EVERETT MALL WAY WALMART 2024-02-29

AWAS((((*))) /1M?LIFIED WIRELESS SOLUTIONS, INC Cable and Component Testing Perform and record a sweep test of every cable section using an FDR sweep, by utilizing a 50 ohm load terminator on the end of each cable. Test all sections of cable with 2 connectors at common frequency bands for application (765-855 MHz Etc. to cover 700/800 frequencies) On test results no return loss at any connector along the cable segment shall be greater than 20 db. If more a cable check needs to be done on the run for bends or tears if present replace bad section and re -test cable. General Notes and Procedures 1. Plans are not scaled and for outline only, unless otherwise noted. 2. Before submission of pre -construction drawings, the site will be visited and confirmed that the work will be completed as presented before construction begins. 3. All equipment and materials will be installed in accordance with the manufacturer recommendations unless indicated otherwise or where dictated local codes or regulations are needed. 4. All work performed and materials installed shall be in accordance with all applicable codes, regulations and city ordinances, mechanical and electrical systems will be installed in accordance with all city and state municipal and utility company specifications. 5. The project manager will supervise and direct the work with great attention to detail. Also be solely responsible for all construction methods, techniques and procedures and for coordinating all portions of the project with the site and landlord's authorized contact. 6. All construction shall be in accordance with the City of Everett municipal code and all adopted state codes including addendums specifically set forth by the City of Everett. 7. Details are intended to show final result of design. Minor modifications may be required as project is installed. 8. As a general rule, the project manager will keep the area clean, hazard free and dispose of garbage properly. 9. Penetrations of roof membranes shall be patched/flashed and made watertight to protect the property owner. 10. All circuits to be used to power the DAS shall be approved by the electrical engineer for 120V power for the DAS and provide #2 bare copper ground at the head -end equipment location. 11. All wall mounted DAS equipment will be securely mounted on 3/4" backboard. 12. Attach J hooks to 1/2" cabling at 4' minimum sections when not installed in conduit or in supported raceways. 13. Bend radius of 1/2" coax has a minimum of 10" Amplified Wireless Solutions, Inc. 6000 NE 881h St., Bldg C, Suite 107 Vancouver, WA 98665