5901 23RD DR W ZAP ENERGY 2024-04-12

Kidde Fire Systems NaturaTM Inert Gas System Component Description IG-100 Nitrogen Cylinder Assembly FEATURES • Inert Gas Clean Agent Fire Suppression • Safe for Personnel and Equipment • Leaves No Residue • Environmentally Friendly • Release Unit offers Electric or Manual Actuation Kidde Fire Systems NaturaTM Inert Gas System (Natura IGS) using IG-100 (herein referred to as Agent) are fixed fire extinguishing systems that use the inert gas Nitrogen, UN number 1066. Nitrogen is colorless, odorless, non- flammable and nontoxic as a gas. Nitrogen is the most abundant gas in the Earth's atmosphere. The Natura IGS uses steel cylinders for gas storage. Each cylinder is manufactured in accordance with ISO 9809-2 and certified to TPED and/or UN/DOT. Each cylinder is fitted with a pressure operated Natura IGS High Pressure cylinder valve. The valve assembly is equipped with a safety burst disc in compliance with DOT and/or TPED requirements. Each cylinder valve has con- nection ports for the release unit or secondary gauge assembly, pilot line actuation hoses, and an agent dis- charge port. Each cylinder and valve assembly is provided with an anti -recoil cap and a transport cap (Designed and tested to ISO 11117) as a safety feature designed to prevent uncontrolled, accidental discharge. or Kidde Fire Systems Effective: April 2021 K-38-2005 Rev AC • Available in two High-pressure options (200 bar and 300 bar) for 80 Liter Cylinder • Available in 300 bar for 140L Cylinders • For Approvals, see the "COMPATIBILITY" table. • REACH and RoHS compliant Standard cylinders are available in volumes of 80 liters filled with agent at pressures of 200 bar or 300 bar at a filling temperature of 15°C and 140 liters filled with agent WARNING at pressures of 300 bar at a filling temperature of 15°C. The cylinders are provided with the body painted red and green shoulder, with agency markings where applicable. Figure 1 represents a typical cylinder assemblies. The Natura IGS equipment listed herein is designed for an operating temperature range of -4° to 130°F (-20° to 54°C). The safety cap must be installed on the dis- charge outlet whenever a charged cylinder/ valve assembly is not connected to the sys- tem piping. Failure to install the safety cap could result in violent movement of the con- tainer in the event of inadvertent actuation. Failure to follow these instructions could cause death, personal injury and/or prop- erty damage.