Laserfiche WebLink
SOLGEN <br /> P O W E R <br /> September 22, 2023 <br /> Subject: Proposed Solar Panel Installation <br /> John Wiltshire Residence, 3332 Nassau St, Everett, WA <br /> To Whom it May Concern, <br /> Our engineering department has reviewed information, gathered by our field crews, related to the proposed solar <br /> panel installation at the above-referenced address. The purpose of our review was to determine the structural <br /> adequacy of the existing roof for the proposed installation. Based on our review and analysis of the available <br /> information, it is our professional opinion that the existing structure requires a retrofit to ensure structural <br /> adequacy to support the proposed installation. <br /> Provide blocking located at water damage area. The retrofit shall consist of 2x blocking, with 16d common nails at <br /> 24" O.C., staggered. Blocking shall begin and end between 0" and 18" from rafter ends and should happen before <br /> install. <br /> Design Parameter Summary <br /> Governing Building Code: 2018 Washington Building Code (2018 IBC) <br /> Risk Category: II <br /> Design Wind Speed: 110 mph (per ASCE 7-16) <br /> Ground Snow Load: 15 psf <br /> Roof Information <br /> Roof Structure: 2x4 Rafters @ 24" O.C. <br /> Roofing Material: Asphalt Shingles (1 layer) <br /> Roof Slope: 32 degrees <br /> Roof Connection Details <br /> RT Minis into 2x rafters/chords, or decking, at 48" O.C.; install per design drawings and manufacturer specs <br /> Locations per design drawings <br /> Note:Required embedment length excludes the tapered tip of the screw, and embedment into sheathing. <br /> Analysis <br /> The proposed installation complies with the requirements of WAC Section 51-51-03240 R324.4 (Exception) and is <br /> therefore deemed adequate to support the load of the rooftop solar system. <br /> Specifically: 1) the system is designed for the local wind speed; 2) the ground snow load does not exceed 70 psf; 3) <br /> the total dead load of all items is less than 4 psf (actual value is approximately2.88 psf); 4) Modules are not <br /> mounted more than 18" off the roof; and 5) Supports are installed such that the dead load is spread across roof- <br /> framing members and does not exceed 50 lbs at any point. <br />