2130 STATE ST 2024-10-25 - Laserfiche WebLink

Alex Byrd From: Alex Byrd Sent: Friday, March 5, 2021 2:05 PM To: Josh Modisette Subject: RE: PW2012-029 RE: B2011-037 RE: 2130 STATE ST Attachments: 2130 State Street Short Plat Map.pdf, Residential Construction Submittal Checklist (PDF) with attach ments_201904181017087664 (1).pdf Hi Josh, I was able to review the plans for 2130 State Street when I was in the office today(permit 82011-037). In order for the Planning Department to approve the permit, please submit the following: 1. The lot dimensions do not match the short plat map (see attached). Please revise the site plan so the dimensions of the lot are consistent with the short plat map. 2. Please show all easements on the site plan, including the ingress/egress easement for your lot (see attached short plat map). 3. Please note that a survey of the west and north property lines will be required because the proposed garage is within 1-foot of the required 5' side and rear setback(proposed at 6'). Note: if the garage is located more than 6' away from the side and rear property line, a survey is not required. 4. Please provide height calculations. Refer to pages 4-7 of the attached handout for instructions on how to calculate height and what to show on the site plan. It appears the numbers shown on the garage are elevation numbers, but please provide the average base elevation calculations per the checklist. Please note that a base elevation survey and height survey is only required if the proposed height is within 1-foot of the height limit. The height limit is 1%floors up to 18' maximum. 5. On the elevations,the average base elevation needs to be shown and the overall height of the structure measured from the average base elevation (see page 5). 6. EMC 19.08.110 requires detached accessory buildings to be compatible with the main residence, including roof pitch and building materials. Please provide the roof pitch of the main residence so I can verify the 12/4 roof pitch of the garage is consistent. Please also provide more details regarding the building materials of the existing house and proposed garage so I can verify this code requirement is met. 7. EMC 19.08.110 requires accessory structures located within the 20-foot rear setback(required for the principal dwelling) to have a minimum separation from the principal dwelling of 10-feet, not including eaves. The site plan calls out a 7.58' separation, so this requirement is not met. The interim permit intake/resubmittal policy is available on the Permit Services Page. Please submit at minimum 2 copies of any revised documents/plans. These comments are only related to the land use code and do not account for all possible requirements from other departments. For general permit questions, please contact Permit Services at everetteps@everettwa.gov or 425.257.8810. Please let me know if you have any questions. Thanks, i