Laserfiche WebLink
Enter Permit Number E2205-213 <br /> 1 of 1 > I 0 100% V I i Find I Next <br /> City of Everett <br /> 2930 Wetmore Ave. <br /> Everett,WA 98201 <br /> Phone: <br /> Fax: <br /> 10/11/2022 <br /> SUBJECT: E2205-213 <br /> ELECTRICAL <br /> To:Abraham GEDEBO <br /> Here are the results of all Inspections located at 811 94TH ST SE: <br /> Inspection Type: ELEC-SITE READINESS CHECK <br /> Scheduled Date/Time: 6/2/2022 <br /> Completed Date/Time: 6/2/2022 <br /> Inspector: MIKE BEARDA <br /> Result: CORRECTION REQUIRED <br /> Remarks: <br /> Notes: <br /> ABRAHAM.GEDEBO@G MAIL.COM <br /> (6/2/2022 3:26 PM MCB) <br /> Expose all unapproved work(including electrical,mechanical,plumbing,and framing systems <br /> etc.)installed/altered without permits and inspection approval. <br /> (6/3/2022 8:43 AM MCB) <br /> Expose all unapproved work(including electrical,mechanical,plumbing,and framing systems <br /> etc.)installed/altered without permits and inspection approval. <br /> Inspection Type: ELEC-SITE READINESS RECHECK <br /> Scheduled Date/Time: 6/23/2022 <br /> Completed Date/Time: 6/23/2022 <br /> Inspector: MIKE BEARDA <br /> Result: NOT READY <br /> Remarks: <br /> Notes: <br /> ABRAHAM.GEDEBO@GMAIL.COM <br /> (6/23/2022 3:20 PM MCB) <br /> Expose all unapproved work(including electrical,mechanical,plumbing,and framing systems <br /> etc.)installed/altered without permits and inspection approval. <br /> Inspection Type: ELEC-SITE READINESS RECHECK <br /> Scheduled Date/Time: 7/28/2022 <br /> Completed Date/Time: 7/28/2022 <br /> Inspector: STEVE BANKS <br /> Result: READY <br /> Remarks: <br /> Notes: <br /> ABRAHAM.GEDEBO@GMAIL.COM <br /> Inspection Type: ELEC 06-ROUGH IN <br /> Scheduled Date/Time: 7/28/2022 <br /> Completed Date/Time: 7/28/2022 <br /> Inspector: STEVE BANKS <br /> Result: CORRECTION REQUIRED <br /> Remarks: <br /> Notes: <br /> Provide GFCI protection for the bathroom receptacle.You must physically protect the NM cables <br /> were there installed within one and a quarter inch of the edge of the studs or secure them in <br /> the center of the studs.Ground all metal in boxes.Provide AFCI protection for all replaced <br /> receptacles and extended circuits And or new branch circuits.All new and or replaced <br /> receptacles must be the tamper resistant type.Provide GFCI and AFCI protection for the laundry <br /> circuit.Provide GFCI protection for the dryer receptacle.Provide a four wire receptacle for the <br /> dryer.Not ready.Heat circuit seem to be overloaded.Raise all junction boxes above the <br /> insulation line in the attic which is 16 inches. <br /> � f � <br />