215 SHUKSAN WAY 2024-06-24 - Laserfiche WebLink

BACKWARDS COMPATIBILITY TECHNICAL SPECIFICATIONS (cont'd) The AEGIS 2.0 is backwards compatible and listed for One (1)Abort Circuit use with a full range of conventional detectors and alarm -Compatible with normally open contact-closure type devices as well as suppression accessories from Kidde, devices Fenwal and Chemetron. Going forward, this will allow - Configurable as Class A/Style D or Class B/Style B legacy panels to be replaced with relative ease. - Supervised for ground faults and open circuits EASY TO INSTALL CABINET - Six (6)Abort Modes available The cabinet design allows for easy installation by fitting - Power-limited between the studs of a standard 16 inch studded wall. It Two (2) Supervisory Circuits is large enough to house two 12 VDC, 12 AH Batteries -Compatible with normally open contact-closure type and provides up to 2 inches (51 mm) of wiring and finger devices space between the circuit board and the cabinet wall. - Configurable as Class A/Style D or Class B/Style B An optional door design features a Manual Release and - Option to use SUP 1 as 4th detection circuit Abort switch for applications with space constraints. Both - Supervised for ground faults and open circuits switches incorporate guards that prevent their - Power-limited inadvertent activation. Three (3) Notification Appliance Circuits (NACs) TECHNICAL SPECIFICATIONS - Compatible with polarized 24 VDC Audio-Visual Hazards Protected devices • - Rated at 1.5 Amps each - One - Up to 35 synchronized appliances • Power Supply - Configurable as Class A/Style Z or Class B/Style Y - 120/240 V, 50/60 Hz (90 to 264 Vrms, 47 to 63 Hz) - Supervised for ground faults, shorts, and open AC Main Input circuits -5.4 Amps at 27 VDC Output - Power-limited - Battery capacity up to 68 AH @ 24 VDC - Common NAC/ARC output disconnect switch -Auxiliary power output rated at 1 Amp at 18.8-27.6 Two (2) Agent Release Circuits VDC (resettable) - Each compatible with 1 or 2 control heads, or 1 • Three (3) or Four(4) Detection Circuits actuator/initiator, or 1 FM sprinkler solenoid -Compatible with 700 Series, CPD-705x, PSD-715x, - Circuits electrically capable of simultaneously and THD-705x detectors as well as Normally Open releasing any combination of two of the above contact closure type devices. Refer to documents devices K-70-100 and F-70-63 for details on compatibility - Factory configured as Class B/Style Y and the maximum number of devices supported. - Supervised for ground faults and open circuits - Configurable as Class A/Style D or Class B/Style B - Default setting: Power-Limited. Each solenoid on a - Supervised for ground faults and open circuits power-limited ARC requires the use of an in-line - Power limited releasing device, P/N 06-220023-001 (order - DET 1 and DET 2 used for suppression separately, not included with panel). - DET3/WF configurable for detection or waterflow - Common NAC/ARC output disconnect switch - Option to use SUP 1 circuit as DET 4 circuit Four(4) Relays • One (1) Manual Release Circuit - 3 independently programmable, normally de- -Compatible with normally open contact-closure type energized Form-C Relays devices - 1 dedicated normally energized Form-C Trouble - Configurable as Class A/Style D or Class B/Style B Relay - Supervised for ground faults and open circuits - Relay contacts rated 3 Amps at 30 VDC/120 VAC - Power limited (resistive) - 4 -