215 SHUKSAN WAY 2024-06-24 - Laserfiche WebLink

WIRING DIAGRAMS 3. Contact Kidde for Installation Instruction sheets on these products. These materials contain important information that should be read prior to specifying or MT SIGNAL PROM installing these products, including: PRECEDING + + TO NEXT APPLIANCEAPPLIANCE Total current required by all devices connected to SM/DSMSM - - OR EOLR OR FACE system primary and secondary power sources. • Fuse ratings on signaling circuits to handle maxi- mum inrush or peak currents from all devices on those circuits. SIG""` • Composite flash rate from multiple strobes within a person's field of view. AUDIBLE SIGNAL AND STROBE Installation in office areas and other specification OPERATE INDEPENDENTLY and installation issues. FROM Use strobes only on circuits with continuous) PRECEDING + + TO NEXT y y AUDIBLE OR APPLIANCE FACP - - OR EOLR applied operating voltage. Do not use strobes on FROM + + TG NEXT coded or interrupted circuits in which the applied PRECEDING APPLIANCE, STROBE OR FACE - - OR EOLR voltage is cycled on and off, as the strobe may not flash. • The voltage applied to these products must be + - :04 + within their rated input voltage range. • Conductor size (AWG), length and ampacity STROBE AUDIBLE should be taken into consideration prior to design and installation of these products, particularly in AUDIBLE SIGNAL AND STROBE retrofit installations. OPERATE IN UNISON,RED AND 4. These notification appliances must be used within BLACK SHUNT-WIRES ARE their published specifications and must be PROP- SUPPLIED. ERLY specified, applied, installed, operated, main- PRECEDING + RED + TO NEXT APPLIANCE, _ APPLIANCE tained and operationally tested in accordance with OR FACP BLACK - OR EOLR their installation instructions at the time of installa- tion and at least twice a year or more often and in + - 0 + - accordance with local, state and federal codes, reg- ulations and laws. Specification, application, installa- STROBE AUDIBLE tion, operation, maintenance and testing must be performed by qualified personnel for proper opera- tion in accordance with all of the latest National Fire INSTALLATION NOTES Protection Association (NFPA), Underwriters' Labo- ratories (UL), National Electrical Code (NEC), Occu- 1. If the strobe and audible operate on the same cir- pational Safety and Health Administration (OSHA), cuit, add the strobe current from Table 2 to the audi- local, state, county, province, district, federal and ble current from Table 3. For Peak and Inrush other applicable building and fire standards, guide- current across the listed voltage range, refer to lines, regulations, laws and codes including, but not Installation Instructions. limited to, all appendices and amendments and the 2. The average current indicated is per actual Produc- requirements of the local Authority Having Jurisdic- tion Testing at listed VDC. For rated average and tion (AHJ). Peak current across the UL listed voltage range for both filtered DC and unfiltered VRMS, see Installa- tion Instructions. Failure to comply with the installation instruction sheets could result in improper © installation, application, and/or operation WARNING of these products in an emergency situa- tion,which could result in property damage and serious injury or death. - 3 -