Laserfiche WebLink
Insulation Certificate for Residential New Construction <br />Permit # <br />House address or lot number: Harrison Pointe Unit Q (Lot 17) <br />Walls Blown or sprayed Fiberglass or Cellulose — Walls <br />Type of insulation: Fiberglass R-Value per Inch: <br />Manufacturer: O.C. Coverage Area: <br />R-Value: 21 <br />Floor <br />Type of insulation: Fiberglass <br />Manufacturer: O.C. <br />R-Value: 38 <br />Flat Ceiling/ Attic <br />Type of insulation: Fiberglass <br />Manufacturer: O.C. <br />R-Value: 49 <br />Single Rafter Joist Vaulted Ceiling <br />Type of insulation: _ <br />Manufacturer: <br />R-Value: <br />Insulation Installer: <br />Company Name: Ecc <br />Office Signature <br />Phone Number: <br />Bag Count: — <br />Blown or Sprayed Fiberglass or Cellulose — Ceiling <br />R-Value per Inch: 3.3 <br />Coverage Area: 45 <br />Bag Count: 33 <br />Sprayed Polyurethane Foam (SPF) <br />Density: <br />Installed Thickness: <br />R-Value of Installed Thickness: <br />Building Component installed: walls floor ceiling <br />Jmin: Stesha Kirk <br />Date: 4.10.24 <br />Washington State Energy Code Reference http://www.energ)f.wsu.edu/Documents/2012%20Res%2OEnergy.pdf : <br />R303.1 Identification. Materials, systems and equipment shall be identified in a manner that will allow a determination of compliance with the <br />applicable provisions of this code. <br />303.1.1 Building thermal envelope insulation. An R value identification mark shall be applied by the manufacturer to each piece of building thermal <br />envelope insulation 12 inches (305 mm) or greater width. Alternately, the insulation installers shall provide a certification listing the <br />type, manufacturer and R-value of insulation installed in each element of the building thermal envelope. For blown or sprayed <br />insulation (fiberglass and cellulose), the initial installed thickness, settled thickness, settled R-value, insulation density, coverage area <br />and number of bags installed shall be listed on the certification. For sprayed polyurethane foam (SPF) insulation, the installed <br />thickness of the areas covered and R-Value of installed thickness shall be listed on the certification. The insulation installer shall <br />sigh, date and post certification in a conspicuous location on the job site. <br />Scanned with CamScanner <br />