2706 21ST ST 2024-07-22 - Laserfiche WebLink

Drew Martin From: Drew Martin Sent: Tuesday, December 7, 2021 10:51 AM To: willtrimble@live.com Subject: City of Everett Permit Services: 2706 21st Street (132111-005) - First Building Intake Review Attachments: 2018 IRC-Typical Code References_04-12-2021.docx; CoE_Residential Drawing Preparation-Edited 09-27-2021.pdf Hello, Will. Your application has been received and a permit set up. However, the submitted documents are not sufficiently developed for us to perform a comprehensive review at this time. Information is attached to provide guidance. Construction-level documents should be submitted for review. Two complete sets of the revised drawings should be submitted to replace the previously submitted drawing sets. Preliminary comments are provided below to assist in preparing the drawings, but these are not intended to provide a comprehensive review. The resubmittal documents should include an itemized response letter clarifying how the review comments below have been addressed. Depending on your experience with the adopted codes and preparing documents, we recommend consulting with a design professional to assist you. Intake Review Comments: General: 1. The submitted documents include sketches for the proposed project. Construction-level drawings prepared using established drafting standards are required to substantiate compliance with the IRC. The drawings should be prepared using a standard scale (e.g, %"=1'-0") and be printed on a paper size consistent with the drawing scale(s). The drawings should include plans, building sections, details, material specifications, design loads, architectural and structural notes, etc. as needed to clearly show the proposed work. See IRC Section R106.1.1. 2. The project should specify the applicable building codes, including but not limited to the 2018 IRC, 2018 WSEC, and the 2018 IBC. See Section R106.1.1 and EMC Section 16.005.030. 3. The drawings should clearly delineate between existing and new work using established drafting standards. All demolition should be shown on the existing floor plans. All new construction should be shown on the new floor plan. Where the proposed project includes modifications existing building components (e.g., gypsum wall board, insulation, etc.), these components should be similarly delineated from existing component that are not being altered. See IRC Section R106.1.1. 4. The scope of work appears to be incomplete. Based on photos obtained by the Code Enforcement department under File No. CE21-0821, additional modifications to the house may include but are not limited to modifying interior walls and demolition of the rear covered porch and stairs. The CE file also shows that the main egress stairs at the front of the house are deteriorated and should be replaced. The 1