1820 SILVER LAKE RD 2025-04-21 - Laserfiche WebLink

Shyamal Gounder Shyvani Investments LLC Plan Check Number: B2103-052, First Building Review February 9, 2022 Architectural 1. See Sheet A-1.1 and Section 1/A-4.2. The garage should be separated from habitable rooms above with not less than 5/8-inch Type X gypsum board or equivalent. See Table R302.6. 2. See Office and Hall on Sheet A-1.4. Safety glazing should be specified for all glass walls. R308.4 3. See Detail 6/A-5.1 and Section 2/A-3.1. The window well shows an emergency ladder and a glass guardrail at the top of the window well walls. The glass railing is preventing the ability to exit the window well at the top of the ladder. The ladder should be extended to the top of the glass guardrail or provide an access to exit from the top of the ladder. 4. See Sheet A. 1-3. It appears that solar panels are included on the roof. Please see attached document for the Residential Photovoltaic Permit Application. See Sheet A-1.3 and A-4.3. The plans appear to show a glass roof. The size of the glazing appears to not meet the requirements of where screens below the glass are not required (R308.6.5). A screen meeting the requirements of Section R308.6.7 should be installed below the glass. R308.6.3. Structural 1. See Sheet S5. It appears that Detail 1/S11 is referenced on Grid Line A and between Grids 6 and 7, but Detail 1/S11 does not apply. A 2'-6" parapet is specified on the plans per Detail 1/S11, and roof joists appear to frame perpendicular to the wall but Detail 1/S11 is a gable end support detail with no parapet. R106.1.1 2. See Sheet S5. It appears that Detail 3/S11 is referenced on Grid 7, but the detail appears to be incorrect. Plans show joists parallel to the wall, but detail shows framing perpendicular to the wall. R106.1.1 3. The structural drawings should include a statement of "Deferred Submittals" listing work designated as deferred submittals. See IBC Sections 107.2.1, 107.3.4, 107.3.4.1, and 107.4. The note should be revised as follows: a. The submittals should be prepared and signed by a professional engineer licensed in the state of Washington. b. The submittals should be reviewed for conformance with the approved construction drawings and the applicable building codes and marked for approval by the engineer -of - record (EOR) prior to fabrication and installation. 4. Plans appear to show a canopy welded to the upper beam that is specified to be designed by others on Sheet S5, Grid Line 3. The following comments should be addressed. a. The canopy should be included in the list of deferred submittals. See the previous comment for more information. 3200 Cedar Street © 425.257.8810 O everetteps@everettwa.gov Everett, WA 98201 425.257.8857 fax everettwa.gov/permits Page 2 of 5