Laserfiche WebLink
w • <br /> 8. Replace the"49"spud with a"57"spud.Install the LP gas <br /> To Convert Oven Bake Burner(Natural Gas to LP Gas) bake burner orifice spud,turning it clockwise until snug. <br /> IMPORTANT:Do not overtighten. <br /> 1. Remove the oven racks. <br /> 2. Remove 2 screws at the rear of the oven bottom. �,, A <br /> 3. Lift the rear of the oven bottom up and back until the front of <br /> the panel is away from the front frame.Remove from oven <br /> and set it aside on a covered surface. •;�ih`'I j <br /> ,� .Ili <br /> �!'�/ rr r <br /> lk VIII <br /> iii <br /> A Screws A Orifice spud <br /> B.Oven bottom <br /> 9. Position the back of the bake burner over the oven orifice, <br /> 4. Remove 2 screws from the front tabs of the flame spreader and slide the tab on front of the bake burner into the front of <br /> Lift front of the flame spreader and pull forward to remove the oven. <br /> tabs from rear of oven and set it aside on a covered surface. 10.Reattach the bake burner with 2 screws. <br /> B 11.Insert the tabs on the rear of the flame spreader into the rear <br /> of the oven. <br /> f 12.Reattach the front tabs of the flame spreader to the oven with <br /> 72 2 screws. <br /> 13.Position the front of the oven bottom panel toward the front <br /> frame and lower the rear of the oven bottom panel into the <br /> oven. <br /> 1 14.Reattach the oven bottom panel with 2 screws. <br /> � <br /> A To Convert Oven Broil Burner(Natural Gas to LP Gas) <br /> A.Screws 1. Remove the screw from the broil burner. <br /> B.Flame spreader 2. Remove the broil burner from the broil burner orifice hood. <br /> 5. Remove 2 screws from the bake burner. NOTE:The broil burner will hang in the back of the oven while <br /> you are changing the orifice hood. <br /> 6. Slide the front of the bake burner to the side to remove tab <br /> from front of oven.Lift the back of the bake burner off the <br /> oven orifice,and set the bake burner aside. <br /> J t A <br /> 9 <br /> ` is <br /> i <br /> « A <br /> Jam. C <br /> A.Screws <br /> B.Bake burner A.Broil burner <br /> B.Screws <br /> 7. Use a 3/8"nut driver or combination wrench and turn the C.Orifice hood <br /> Natural gas bake burner orifice spud counterclockwise to <br /> remove.The spud will be stamped with a"49." 3. Use a 3,6"combination wrench and turn the Natural gas broil <br /> burner orifice hood counterclockwise to remove.The hood <br /> will be stamped with a"151." <br /> 16 <br />