Laserfiche WebLink
• <br /> INSTALLATION REQUIREMENTS <br /> Tools and Parts Lac 'on Requir <br /> Gather the required tools and parts before starting installation. IMPORTANT:Observe all governing codes and ordinances.Do <br /> Read and follow the instructions provided with any tools listed not obstruct flow of combustion and ventilation air. <br /> here. • It is the installer's responsibility to comply with installation <br /> Tools needed clearances specified on the model/serial rating plate.The <br /> model/serial rating plate is located on the oven frame behind <br /> • Tape measure ■ Marker or pencil the top left side of the oven door. <br /> • Flat-blade screwdriver • Pipe-joint compound ■ Recessed installations must provide complete enclosure of <br /> • Phillips screwdriver resistant to LP gas the sides and rear of the range. <br /> • Level ■ Noncorrosive leak-detection ■ All openings in the wall or floor where range is to be installed <br /> solution must be sealed. <br /> • Hand or electric drill For LP/Natural Gas <br /> ■ Do not seal the range to the side cabinets. <br /> • Wrench or pliers Conversions <br /> • Pipe wrench ■ 3/a"combination wrench • Cabinet opening dimensions that are shown must be used. <br /> p Given dimensions are minimum clearances. <br /> • Wie"combination wrench • 'h"combination wrench • The anti-tip bracket must be installed.To install the anti-tip <br /> • '/a"drive ratchet • %"combination wrench bracket shipped with the range,see"Install Anti-Tip Bracket" <br /> • %" nut driver • 7 mm(9/a")nut driver section. <br /> • Grounded electrical supply is required.See"Electrical <br /> • '/s"(3.2 mm)drill bit(for • Quadreet or Phillips Requirements"section. <br /> wood floors) screwdriver <br /> ■ Masking tape • Proper gas supply connection must be available.See"Gas <br /> Supply Requirements"section. <br /> Parts supplied • Contact a qualified floor covering installer to check that the <br /> Check that all parts are included. floor covering can withstand at least 200°F(93°C). <br /> • Use an insulated pad or�/4"(6.4 mm)plywood under range if <br /> rA installing range over carpeting. <br /> IMPORTANT:To avoid damage to your cabinets,check with your <br /> B builder or cabinet supplier to make sure that the materials used <br /> will not discolor,delaminate or sustain other damage.This oven <br /> ° has been designed in accordance with the requirements of UL <br /> and CSA International and complies with the maximum allowable <br /> wood cabinet temperatures of 194°F(90°C). <br /> o ° Mobile Home-Additional Installation Requirements <br /> The installation of this range must conform to the Manufactured <br /> Home Construction and Safety Standard,Title 24 CFR,Part 3280 <br /> (formerly the Federal Standard for Mobile Home Construction <br /> A.Anti-tip bracket and Safety,Title 24,HUD Part 280).When such standard is not <br /> 8.#12 x 1%"screws(2) applicable,use the Standard for Manufactured Home <br /> Installations,ANSI A225.1/NFPA 501A or with local codes. <br /> • Anti-tip bracket must be securely mounted to floor or wall. Mobile home installations require: <br /> Thickness of flooring may require longer screws to anchor <br /> bracket to floor. • When this range is installed in a mobile home,it must be <br /> secured according to the instructions in this document. <br /> Parts needed <br /> Check local codes and consult gas supplier.Check existing gas <br /> supply and electrical supply.See"Electrical Requirements"and <br /> "Gas Supply Requirements"sections. <br /> QUADREX is a registered trademark of NLW Holdings,Inc. <br /> 3 <br />