1718 W MARINE VIEW DR 2021 Plans 2024-07-30 (4)

• J Electricalwire Gas Supply Requirements ©WARNING AWARNING 1 Electrical Shock Hazard Explosion Hazard Plug into a grounded 3 prong outlet. Use a new CSA International approved gas supply line. Do not remove ground prong. Install a shut-off valve. Do not use an adapter. Securely tighten all gas connections. Do not use an extension cord. If connected to LP,have a qualified person make sure gas pressure does not exceed 14"(36 cm)water Failure to follow these instructions can result in death, column. fire,or electrical shock. Examples of a qualified person include: IMPORTANT.The range must be electrically grounded in licensed heating personnel, accordance with local codes and ordinances,or in the absence authorized gas company personnel,and of local codes,with the National Electrical Code,ANSI/NFPA 70 authorized service personnel. or Canadian Electrical Code,CSA C22.1. Failure to do so can result in death,explosion,or fire. This range is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized. Observe all governing codes and ordinances. If codes permit and a separate ground wire is used,it is IMPORTANT:This installation must conform with all local codes recommended that a qualified electrical installer determine that and ordinances.In the absence of local codes,installation must the ground path is adequate. conform with American National Standard,National Fuel Gas A copy of the above code standards can be obtained from: Code ANSI Z223.1 -latest edition or CAN/CGA B149-latest National Fire Protection Association edition. 1 Batterymarch Park IMPORTANT:Leak testing of the range must be conducted Quincy,MA 02169-7471 according to the manufacturer's instructions. CSA International 8501 East Pleasant Valley Road Hype of Gas Cleveland,OH 44131-5575 • A 120 volt,60 Hz.,AC only,15-amp fused,electrical circuit is Natural gas: required.A time-delay fuse or circuit breaker is also ■ This range is factory set for use with Natural gas.See"Gas recommended.It is recommended that a separate circuit Conversions"section.The modeVserial rating plate located serving only this range be provided. on the oven frame behind the top left side of the oven door • Electronic ignition systems operate within wide voltage limits, has information on the types of gas that can be used.If the but proper grounding and polarity are necessary.Check that types of gas listed do not include the type of gas available, the outlet provides 120-volt power and is correctly grounded. check with the local gas supplier. • This gas range is not required to be plugged into a GFCI LP gas conversion: (Ground-Fault Circuit Interrupter)outlet.It is recommended Conversion must be done by a qualified service technician. that you not plug an electric spark ignition gas range or any No attempt shall be made to convert the appliance from the gas other major appliance into a GFCI wall outlet as it may cause specified on the modeVserial rating plate for use with a different the GFCI to trip during normal cycling. gas without consulting the serving gas supplier.See"Gas • Performance of this range will not be affected if operated on a Conversions"section. GFCI-protected circuit.However,occasional nuisance tripping of the GFCI breaker is possible due to the normal operating nature of electronic gas ranges. • The wiring diagram is located on the back of the range in a clear plastic bag. NOTE:The metal chassis of the range must be grounded in order for the control panel to work.If the metal chassis of the range is not grounded,no keypads will operate.Check with a qualified electrician if you are in doubt as to whether the metal chassis of the range is grounded. 5