2316 GRAND AVE 2024-10-11 - Laserfiche WebLink

i Permit Inspections V E R E T T City of Everett WASHINGTON Permit Number: P2302-006 Description: PLUMBING-UNDER SLAB DRAINS FOR ACCESSORY BUILDING Applied:2/6/2023 Approved: 2/6/2023 Site Address: 2316 GRAND AVE Issued:2/6/2023 Finaled: City,State Zip Code: EVERETT,WA 98201-2714 Status: EXPIRATION NOTICE SENT Applicant: ROBERT CARKEEK Parent Permit: B2111-061 Owner:CARKEEK ROBERT J Parent Project: Contractor: OWNER Details: SCHEDULED DATE COMPLETED DATE TYPE INSPECTOR RESULT REMARKS PLUMB 02- CORRECTION 2/28/2023 2/28/2023 GROUND JEFF M RHODE REQUIRED see notes WORK/SLAB Notes: -no vent on floor drain trap 901.2 Vents Required Each plumbing fixture trap,except as otherwise provided in this code,shall be protected against siphonage and backpressure,and air circulation shall be ensured throughout all parts of the drainage system by means of vent pipes installed in accordance with the requirements of this chapter and as otherwise required by this code. -trap primer needed for floor drain 1007.1 General Floor drain or similar traps directly connected to the drainage system and subject to infrequent use shall be protected with a trap seal primer,except where not deemed necessary for safety or sanitation by the Authority Having Jurisdiction.Trap seal primers shall be accessible for maintenance. -waste and vent underground system not tested with 10 feet of head pressure 712.2 Water Test The water test shall be applied to the drainage and vent systems either in its entirety or in sections.Where the test is applied to the entire system, openings in the piping shall be tightly closed,except the highest opening,and the system filled with water to the point of overflow.Where the system is tested in sections,each opening shall be tightly plugged,except the highest opening of the section under test,and each section shall be filled with water,but no section shall be tested with less than a 10 foot head of water(30 kPa). In testing successive sections,not less than the upper 10 feet(3048 mm)of the next preceding section shall be tested,so that no joint or pipe in the building(except the uppermost 10 feet(3048 mm)of the system)shall have been submitted to a test of less than a 10 foot head of water(30 kPa).The water shall be kept in the system,or in the portion under test,for not less than 15 minutes before inspection starts.The system shall then be tight at all points. -toilet and sink located in utility room at back of shop PLUMB 02- CORRECTION 3/2/2023 3/2/2023 GROUND JEFF M RHODE REQUIRED see notes WORK/SLAB Notes: -add vent for floor drain 901.2 Vents Required Each plumbing fixture trap,except as otherwise provided in this code,shall be protected against siphonage and backpressure,and air circulation shall be ensured throughout all parts of the drainage system by means of vent pipes installed in accordance with the requirements of this chapter and as otherwise required by this code. -non metal shielded coupling on abs waste pipe replace with metal shielded coupling I Printed:Thursday, 12 September,2024 1 of 3 rk SUPERION