3201 SMITH AVE BASE FILE 2024-10-14

4V SimplEx TrueAlarm Analog Sensors- Photoelectric and Heat; Standard Bases and Accessories 4098-9714 Photoelectric Sensor TrueAlarm photoelectric sensors use a stable,pulsed infrared LED light source and a silicon photodiode receiver to provide consistent and accurate low power smoke sensing.Seven levels of sensitivity are available for each individual sensor,ranging from 0.2%to 3.7%per foot of smoke obscuration. Sensitivities of 0.2%,0.5%,and 1%are for special applications in clean areas.Standard sensitivities are 1.5%,2.0%,2.5%,3.0%,and 3.7%.Application type and sensitivity are selected and then monitored at the fire alarm control panel.* The sensor head design provides 360'smoke entry for optimum response to smoke from any direction.Due to its photoelectric operation,air velocity is not normally a factor,except for impact on area smoke flow. -7/8"(124 mm II'*--LED status indicator 2-1/8" (54 mm) Figure 4: 4098-9714 Photoelectric Sensor with Base 4098-9733 and 4098-9734 Heat Sensors TrueAlarm heat sensors are self-restoring and provide rate compensated,fixed temperature sensing,selectable with or without rate-of-rise temperature sensing.Due to its small thermal mass,the sensor accurately and quickly measures the local temperature for analysis at the fire alarm control panel. Rate-of-rise temperature detection is selectable at the control panel for either 15'F(8.3°C)or 20°F(11.1°C)per minute.Fixed temperature sensing is independent of rate-of-rise sensing and programmable to operate at 135°F(57.2°C)or 155'F(68'Q.In a slow developing fire,the temperature may not increase rapidly enough to operate the rate-of-rise feature.However,an alarm will be initiated when the temperature reaches its rated fixed temperature setting. TrueAlarm heat sensors can be programmed as a utility device to monitor for temperature extremes in the range from 32°F to 155°F(0°C to 68°Q. This feature can provide freeze warnings or alert to HVAC system problems.Refer to specific panels for availability. 4-7/8"(124 mm) -7/8"(124 mm) T - —LED status indicator LED status indicator 2-3/8" 2-3/8" (60 mm) (60 mm) Figure 5: 4098-9733 Heat Sensor with Base Figure 6: 4098-9734 High Temperature Heat Sensor with Base WARNING:In most fires,hazardous levels of smoke and toxic gas can build up before a heat detection device would initiate an alarm.In cases where Life Safety is a factor,the use of smoke detection is highly recommended. Application Reference Sensor locations should be determined only after careful consideration of the physical layout and contents of the area to be protected.Refer to NFPA 72,the National Fire Alarm and Signaling Code.On smooth ceilings,smoke sensor spacing of 30 ft(9.1 m)may be used as a guide.* *For detailed application information including sensitivity selection,refer to Installation Instructions 574-709. TrueAlarm Analog Sensing Product Selection Chart Table 2:TrueAlarm Sensor Bases(for use with Sensors 4098-9714 and 4098-9733) SKU Color Description Compatibility Mounting Requirements —�4098-9792 White 4"octagonal or 4"square box, 4098-9776 Black Standard Sensor Base No options 1-112"min.depth;or single gang box,2"min.depth Page 4 S4098-0019 Rev.25 01/2020