1111 80TH ST SW 100 JAMCO 2025-01-23

AND SIZE OF FASTENERS AS SPECIFIED BY MANUFACTURER OR AS INDICATED IN THIS DOCUMENT. CONNECTORS SHALL BE INSTALLED IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS. 9. SHEET METAL SCREWS SHALL BE ITW BUILDEX TEKS SELECTTM SELF-DRILLING STRUCTURAL FASTENERS OR AN APPROVED EQUAL. 10. WOOD SCREWS SHALL CONFORM TO ANSI/ASME STANDARD B18.6.1. 11. NAILS UTILIZED SHALL HAVE THE FOLLOWING MINIMUM PROPERTIES: NAIL 8d 10d 16d SHANK DIAMETER 0.131" 0.148' 0.148" HEAD DIAMETER 0.281" 0.312" 0.344" MINIMUM LENGTH 2-1/2" 3" 3-1/4" 12. STRUCTURAL STEEL SHALL CONFORM TO THE FOLLOWING REQUIREMENTS: TYPE OF MEMBER ASTM SPECIFICATION Fy A. ANGLES A36 36 KSI 13. WELDING SHALL CONFORM TO AWS D1.1 STANDARDS AND BE PERFORMED BY WABO CERTIFIED WELDERS. REMOVE ALL PAINT FROM THE EXISTING STEEL JOISTS IN THE AREAS OF THE NEW STEEL ANGLES PRIOR TO WELDING. 14. CONNECT THE METAL CURB FOR THE EXHAUST FAN TO THE WOOD ROOF STRUCTURE WITH THREE(3)#12 x 2-1/2"LONG WOOD SCREWS ON EACH SIDE OF THE CURB. PLACE ONE SCREW AT 4"TO 6"FROM EACH CORNER OF THE CURB AND THE REMAINING SCRREW AT APPROXIMATELY THE MIDDLE OF THE CURB ON EACH SIDE. 15. CONNECT THE EXHAUST FAN TO THE METAL CURB WITH THREE(3)#12 TEKS SCREWS AT ON EACH SIDE OF THE FAN. PLACE ONE SCREW AT 6"TO 8"FROM EACH CORNER OF THE FAN AND THE REMAINING SCREW AT APPROXIMATELY THE MIDDLE OF THE FAN ON EACH SIDE. 16. CONNECT THE METAL CURB FOR THE HOOD TO THE WOOD ROOF STRUCTURE WITH #12 x 2-1/2"LONG WOOD SCREWS AT A MAXIMUM OF 12"ON-CENTER ON EACH SIDE OF THE CURB. PLACE ONE SCREW AT 4"TO 6"FROM EACH CORNER OF THE CURB AND THE REMAINING SCREWS EQUALLY SPACED BETWEEN THE CORNERS. 17. CONNECT THE HOOD TO THE METAL CURB WITH A MINIMUM OF THREE(3)#12 TEKS SCREWS AT ON EACH SIDE OF THE FAN. PLACE ONE SCREW AT 6"TO 8"FROM EACH CORNER OF THE HOOD AND THE REMAINING SCRREW AT APPROXIMATELY THE MIDDLE OF THE HOOD ON EACH SIDE.