Laserfiche WebLink
Ms. Nisha Taylor <br />Pye-Barker Fire and Safety, LLC <br />Plan Check Number: M2206-031, Second Building Review <br />October 26, 2022 <br />Comments <br />1. This comment has not been completely addressed. The proposed project appears intended to <br />install a "commercial cooking recirculating system". See the definitions per IMC Section 202, <br />and IBC Section 107.2.1. The following comments should be addressed: <br />c. The system is required to comply with UL 71013. The submitted documentation does not <br />substantiate compliance. See IMC Section 507.1 Exception 2. <br />2. This comment has not been addressed. The ventilation in the area where the hood system is <br />located is required to comply with IMC Section 403.3.1.1. Transcribing this comment into the <br />construction drawings does not address the requirement. Note that the proposed placement in <br />a storage closet is not acceptable; see comments below. Furthermore, this room is not <br />anticipated to have ventilation complying with this requirement. Submit documentation <br />substantiating compliance. See IMC Section 507.1 Exception 2. <br />3. This comment has not been addressed. The hood is required to comply with the minimum <br />clearance requirements of IMC Sections 507.2.6 and 308.4. Documentation substantiating the <br />minimum clearance requirements around the system should be submitted for review. The <br />submitted documentation does not specify these clearances. In addition, the walls surrounding <br />the appliance should be covered with a non -absorbent surface. <br />4. This comment has not been completely addressed. Continuing with the previous comment, the <br />system should be separated from the public by walls or other barriers to provide contact and <br />injury. The proposed location of placing the appliance in a storage closet has been reviewed <br />with the Fire Department and determined to not be an acceptable location for this appliance <br />due to the high fire risk. The proposed location should be revised. A separate building permit <br />is required where significant modifications to existing construction and or to construct new walls <br />occurs. Minor modifications and wall construction may be included in the Type I hood <br />application. Details including top and bottom wall anchorage should be included. See IBC <br />Section 105.1 and IFC Section 104.1. <br />This review has been performed for general compliance with the building codes as adopted and <br />amended by the state of Washington and the city of Everett. Corrections and comments made <br />during the review process do not relieve the project from compliance with code and permit <br />requirements. The designers -of -record are responsible for a complete design in accordance with <br />the laws of the state of Washington. <br />If you have any questions or require additional clarification, please contact us. <br />Respectfully, <br />Drew Martin, P.E., S.E. <br />Associate Engineer / Commercial Plans Examiner <br />(425)257-8813 <br />dmartin@everettwa.gov <br />S:\BMartin\2022\M2206-O3l—R2.docx <br />3200 Cedar Street © 425.257.8810 O everetteps@everettwa.gov <br />Everett, WA 98201 425.257.8857 fax everettwa.gov/permits <br />Page 2 of 2 <br />