3003 W CASINO RD BLDG 45-214 2024-12-05

Fire Terminal (and equipment) C-WEB Network Module The Fire Terminal (Model FT924) consists of the Fire Terminal Board (Model FT12001-U1); the Operating Unit (Model FCM2018-U3 or Model FCM2019-U3), and a one- height-unit(1 HU)system enclosure. Each Model FT924 terminal contains one(1) backlit, 2"—x—4-314"Video Graphics Array (VGA) monochrome LCD .��. screen with LEDs for displaying system status. An audible ' }` will sound when there are 'unacknowledged' events on the system. The display of each operating unit categorizes events by type, providing a separate event tab for Alarm, Gas Alarm, Supervisory, and Trouble events. The quantity of active The C-WEB network module (Model FN2001-U1) is used to events of each type is listed in each event tab. The display network up to 16 FACPs and the Fire Terminal (Model provides two(2)full lines of text message for each event. FT924), via the C-net system bus. The C-WEB network Each event can have a 40-character custom message module is plugged into the Operating Unit (Model describing the location for a given event. In addition to the FCM2018-U3 or Model FCM2019-U3). text message, the system displays the category of the active Model FN2001-U1 supports 'peer-to-peer' networking event: (e.g. — Automatic Alarm, Water Flow, Manual, etc) — between the following systems: the category means more to responding officials than Model FC922 model numbers. Model FC924 The Fire Terminal Boards contain the site-specific program Model FT924 configuration which is created in'Cerberus Works'. The Model FN2001-U1 connects to system-bus inputs and outputs, and the module has ground-fault monitoring, as NOTE:Canadian installations require an 8-event display.The well as an integrated degrade-mode function. Canadian version of the panel firmware enables the 8-event display mode. Redundant networking is accomplished with one (1) network module [simple loop trouble] per panel. There is Digital Alarm Communicator Transmitter electrical isolation between the system bus and the FACP. ' Power Supply Modules • • • The Digital Alarm Communicator Transmitter(DACT) is used to provide communication between the Cerberus PRO fire- alarm control panels (Models FC922 and FC924); one (1) fire terminal (Model FT924) and an off-premises remote monitoring station. Each DACT(Model FCA2015-U1) can also support additional 3rd -party Internet Protocol (IP) and Global System Mobile (GSM) communication technologies, which include: The 170-Watt power supply (Model FP2011-U1) and 300- Telguard and Sur-Gard. Thus, Model FCA2015-U1 is UL Watt power supply (Model FP2012-U1) provide primary, Listed as compatible with 3rd-party communicators: Bosch regulated (24VDC, nominal) power for normal operation to B465, Starlink LTE dual channel versions,Telguard, and DSC. Siemens — Fire Safety systems. Both power supplies are Model FCA2015-U1 connects to the periphery boards,and it filtered and regulated. Model FP2011-U1 is rated 6.5 Amps enables remote transmission of alarms and events via a at 24VDC, nominal. Model FP2012-U1 is rated 11.5 Amps at public telephone line. Additionally, each DACT module 24VDC, nominal. supports two (2) lines and four (4) accounts, and can transmit serial information (including the address of the event)to the monitoring station. Model FCA2015-U1 can be programmed to perform automatic daily testing as often as required. Siemens Smart Infrastructure—Building Products —3— usa.siemens.comlfire