3003 W CASINO RD BLDG 45-312 2024-12-06

Model XTRI-R Through the use of an add ressable 'Form C' relay, the Model XTRI-R relay and contact device input are controlled at the same address. The relay and input contact can be controlled as a separate function from a Siemens compatible FRCP. The relay is typically used where control or shunting of external equipment is required. Model XTRI-D Model XTRI-D is a dual -input module that is designed to supervise and monitor two (2) sets of drycontacts. Model XTRI-D only requires one (1) address, but responds independently to each input. Model XTRI-D is ideal for monitoring a water -flow switch and its respective valve tamper switch. Field -Device Programmer/Test Unit Intelligent Device Interface Module PROGRAMMING HOLES THERE IS NO 4 a DIRECTIVITY - DESIGN FOR DPU CONNECTION. IT T PLUG FROM IS ALLOWED TO THE DPU INSERT THE PLUG PROGRAMMER; AT EITHER DIRECTION TESTER 1. 4" (10.2 cm.) square box 2-1 /8" (5.4 cm.) back box 2 3.5"(89 an) double -gang back box 3. 5" (12.7 cm.) square switch plate, (supplied) NOTES: Each interface module mounts directly to a user - supplied switchbox. The electrical boxes, seen above, are supplied -by -others (60). Models XTRI-D, XTRI-R and XTRI-S mount directly onto a 4-inch (10.2 cm.; square, 2 'V (5.7 cm.) -deep box back box, or to a user -supplied double -gang 3 /2" deep back box. A5" (12.7 cm.) square, off-white faceplate is included in each shipment of a Siemens Model XTRI-series module. Siemens — Fire Safety innovative technology allows Model XTRI-series intelligent interface modules to be programmed via the Siemens field -device programmer I test unit (Model DPU), which is a compact, portable and menu -driven accessory for electronically programming and testing Siemens peripheral modules and devices promptly and reliably. For instance, the field technician selects the accessory's program mode, and enters the desired address. Model XTRI-series interface module is connected to Model DPU with the programming cable provided with the tester. NOTE: Since the XTRI-series of interface modules are advanced initiating devices, the latest Model DPU firmware update is required. Model DPU eliminates the need for cumbersome, unreliable mechanical programming methods (e.g. — dials and rotary switches), and reduces installation and service costs by electronically programming and testing the module prior to installation. When set in 'test' mode, Model DPU will perform a series of diagnostic tests without altering the address or other stored data, allowing technicians to determine if the module is operating properly. Each field -device programmer / test unit operates on AC power or rechargeable batteries, providing flexibility and convenience in the programming / testing of fire -safety equipment from practically any location. Additionally, with the use of a Model DPU unit, there is no longer a cause for concern with any vibration, corrosion and other deteriorating conditions that could negatively affect any electro-mechanical-addressing mechanism. Compatibilities Siemens 'X' modules may be used along with Model ' H'-series intelligent detectors; Model ' HMS' -series addressable manual stations, or any other ' H'-series addressable intelligent module (e.g. Model HZM or Model HCP). Additionally the X- series modules are compatible with all Desiao and Cerberus Pro detectors and aeriDherals of the same circuit. Interspersing 'X' & ' H'-series devices on the same loop is mostly permitted, but there are exceptions: Models HUM (isolation module) and SBGA-34 (audible base) cannot be used with 'X' devices on the same loop. Siemens Smart Infrastructure — Building Products —2— usa.siemens.com/fire