1602 HEWITT AVE 2024-12-30 - Laserfiche WebLink

Job Steps Hazards Controls C Confirm Release of hazardous All electrical and mechanical systems shall be powered down and disconnected before remove of the fuel system. electrical energy or fuel Lockout/tagout/tryout shall be performed only by authorized employees. The authorized employee shall ensure shutdown product. that all energy isolating devices needed to control energy to, or within, the system are identified and that system and is shut down, isolated, blocked, and secured. Any system operated by a remotely controlled source will be complete completely isolated such that it cannot be operated by that or any other source. L mechanical disconnects. The authorized employee shall affix lock and tag to each energy isolating device. When there is a possibility of re- accumulation of stored energy to a hazardous level, verification of isolation shall be continued until the energy control procedure is complete. Before starting work on systems that have been locked/tagged out,the authorized individual shall verify that isolation and de-energization of the system have successfully been accomplished. Demolish Damage to existing All underground lines/utilities shall be located and protected from damage or displacement. Utility companies shall and remove utilities. be contacted to locate and mark the locations and,if they so desire,direct or assist with protecting the underground asphalt. installations. Injury from Operator must wear face shield and gloves in addition to standard PPE. Ensure guards are well maintained and sawcutting machine. properly positioned, blades are straight and tight, and that the right blade is being used. Ensure the saw doesn't exceed that blade speed and that the blade is turning in the intended direction. Keep bystanders at least 100 feet away; ensure nearby workers have proper PPE. Exposure to silica In accordance with the OSHA Compliance Guide for Silica, concrete saw shall be equipped with integrated water during sawcutting. delivery system that continuously feeds water to the blade. Operate and maintain tool in accordance with M manufacturer's instructions to minimize dust emissions. For cutting operations being conducted outdoors for less than four hours, respirators are not required. For cutting operations being conducted outdoors for more than four hours, an air-purifying respirator with a protection factor of 10 (APF10) shall be worn. All workers wearing respirators shall be trained, medically evaluated, and fit-tested. Injury from Always wear safety glasses AND face shield when using jackhammer. Use the right PPE such as gloves, safety boots, jackhammer. ear protection and face protection at a minimum. You can also use vibration-damping gloves when using the jackhammer. Workers should be rotated as possible to eliminate fatigue from workers that could lead to accidents at the job site. Make sure your jackhammer has extra safety features such as a locking mechanism on the drill bit and a trigger control and automatic release.