811 SE EVERETT MALL WAY T MOBILE 2025-01-10

• •� • • . • - - - • r , • • • 2021 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1— Administered by©2024 NEEA,All rights reserved The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the Washington State Energy Code,Commercial Provisions. For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com NA Indicate occupant sensors are configured to automatically reduce lighting power by z 50% when the zone is unoccupied for over 20 minutes;indicate controls are configured to automatically restore lighting to full power when the zone or space is occupied NA C405.2.1.2 Occupant sensor Indicate method of automatic 100%shut-off controls-warehouse (occupancy sensor or time switch) storage areas& library stacks NA C405.2.1.3 Occupant sensor For open plan office areas larger than 300 sf, controls-open plan indicate all general lighting control zones are office areas 5 600 sf NA C405.2.1.3 Occupant sensor Indicate all general lighting control zones are controls-open plan !provided with vacancy controls that are office areas configured to reduce lighting power by not less than 80%when the zone is unoccupied and turn luminaires 100%off when the control zone is unoccupied;indicate unoccupied control zones are configured to stay off or turn on by no more than 20%full power when other control zones in the area are initially occupied. NA C405.2.1.4 Occupant sensor Indicate stairway lighting is provided with controls-enclosed occupancy sensor controls that reduce lighting fire-rated stairwells power by not less than 50%when the stairway • in unoccupied and restore lighting to 100% when it is occupied. NA C405.2.1.5 Occupant sensor Indicate corridor lighting is provided with controls-corridors occupancy sensor controls that reduce lighting power by not less than 50%when the corridor is unoccupied. YES C405.2.2.1 Automatic time Indicate spaces on plans where time switch E111,E112,E113, switch controls controls are configured to turn luminaires ; E114 100%off during unoccupied hours YES Indicate spaces on plans where time switch E111,E112 controls are configured to turn on lighting to full power versus 50%power YES Indicate locations of override switches on Ell 1,E112,E113 plans and the lighting zone(s)served;indicate that the area(s)served by each override switch does not exceed 5,000 sf. NA C405.2.5.2 Daylight zones- Indicate primary and secondary sidelit C405.2.5.4 Sidelit zones daylight zone floor areas on plans NA For small vertical fenestration assemblies (rough opening less than 10%of primary daylight zone floor area)where daylight responsive controls are not required,provide fenestration area to daylight zone floor area calculation(s). NA Indicate toplit daylight zone floor areas on plans. Page 2/15