Laserfiche WebLink
a • ' • • • — • if • • 4 a <br /> 2021 WSEC Requirements for Commercial Buildings including Group R2,R3&R4 over 3 stories&all R1-- Administered by©2024 NEEA,All rights reserved <br /> The following information is necessary to check a permit application for compliance with the lighting systems,motors and electrical system requirements in the <br /> Washington State Energy Code,Commercial Provisions. <br /> For questions about this report,contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br /> NA C405.2.6, Permanently installed Indicate method of automatic off control of <br /> Item 2 lighting in sleeping all installed luminaires in sleeping units <br /> units (vacancy or captive key card control);also <br /> refer to Receptacles. <br /> NA C405.2.6, Lighting for non- For lighting serving non-visual applications <br /> Item 3 visual applications (food warming and lighting for life support of <br /> nonhuman life forms),indicate on plans that <br /> lighting fixtures are controlled independently <br /> from both general area lighting and other <br /> lighting applications within the same space <br /> NA Indicate on plans separate manual controls for <br /> non-visual lighting application fixtures and <br /> applicable automatic lighting controls; <br /> indicate that the area served by each control <br /> device does not exceed 4,000 sf. <br /> NA For task lighting that serves medical&dental <br /> purposes,indicate on plans that lighting <br /> fixtures are provided with manual control that <br /> is independent from general area lighting. <br /> YES C405.2.6, •Means of egress Identify all means of egress lighting fixtures i E111,E112 <br /> Item 5 ;lighting on plans including fixtures that function as <br /> both normal and emergency illumination <br /> YES Provide calculation for total lighting power Ell 1,E112 <br /> density(LPD)of all means of egress lighting <br /> fixtures;if total LPD is>0.01 Watts/SF, <br /> indicate on plans the method of automatic <br /> shut-off control during unoccupied periods <br /> (emergency relay&occupancy sensors,or <br /> signal from building control system). <br /> NA C405.2.8 Advanced lighting For open office areas>_5,000 sf,indicate <br /> controls in open which advanced lighting control system is <br /> office areas provided(luminaire level lighting controls or <br /> networked lighting controls). <br /> NA C405.2.8.1 Luminaire level Where LLLC are provided to comply with <br /> lighting controls C405.2.8,or provided as the alternate lighting <br /> (LLLC) controls compliance method per C405.2,or to <br /> comply with C406.2.4.2 Enhanced digital <br /> interior lighting controls;provide sequence of <br /> operations that describes required LLLC <br /> capabilities and performance parameters <br /> NA C405.2.8.1 Luminaire level Indicate on plans that each LLLC luminaire is <br /> C405.2.8.3 lighting controls configured with occupancy sensing control <br /> (LLLC) functions(including C405.2.1.3 requirements <br /> for open office areas)and continuous full <br /> range dimming controls to brighten or dim <br /> lights based on occupancy and available <br /> daylight;indicate that control strategy <br /> configuration parameters(including high end <br /> trim setpoints per C405.2.8.3)are adjustable, <br /> and that all other required performance <br /> parameters are met. <br /> Page 4/15 <br />