Laserfiche WebLink
3.2.6 M-Set:TIMEOUT <br /> Allows you to change the value of time, after which the device stops playing the show, if it does not <br /> receive a synchronization signal from the transmitter (set in steps of seconds from 1 to 99, standard <br /> 30). The timeout should never be below 6, since the transmitter send the synchronization signal only <br /> every 5 seconds. <br /> 3.2.7 M-Set: LOCK <br /> Allows you to lock the receiver menu. Also allows you to set the code to unlock themenu. <br /> 3.2.8 M-Set: SYS <br /> Allows you to change the System-address of the receiver. <br /> 3.2.9 M-Set: Pos 1-15 (Igntime) <br /> This value should not be changed (a future Update will make use of this menu item, standard 40). <br /> 3.2.10 M-Set: Pos 16-30(Igntime) <br /> This value should not be changed (a future Update will make use of this menu item, standard 340). <br /> 3.2.11 M-Set: Pos 1-15 (20ms pulse) <br /> This value should not be changed (a future Update will make use of this menu item, standard OFF). <br /> 3.2.12 M-Set: pos 16-30 (20ms pulse) <br /> This value should not be changed (a future Update will make use of this menu item, standard ON). <br /> 3.2.13 M-Set:CENTER <br /> Allows you to change the position of the middle (Position 8, 0°) a few degrees to the right or left <br /> (Standard acc. to factory settings). This may be useful if the device cannot be placed completely <br /> horizontal. <br /> 3.2.14 M-Set: Invert <br /> If this is set to "ON", all positions (see 4.1.2) are mirrored (15H1, 14H2, 13H3, 12H4, 11H5, <br /> 10H6, 9(-->7,8=8). <br /> 3.2.15 M-Set: Pos MIN <br /> Allows you to set from which position (1 to 15)the device may use certain sequences. Positions <br /> below the set one will not be used. <br /> AIWave-Sequences are exempt from this. <br /> WARNING <br /> 3.2.16 M-Set: Pos MAX <br /> Allows you to set from which position (1 to 15)the device may use certain sequences. Positions <br /> above the set one will not be used. <br />