2000 HEWITT AVE EVERETT EVENT CENTER 2024-12-31

G-FORCE 3: MODE CHANGE HOW TO CHANGE MODE SETTINGS ON A G-FORCE 3 Essentially there are three modes to the units: PR7: Manual Mode PR2: DMX Mode with 3 channel setting PR3: DMX Mode with 2 channel setting Below 1 will outline how to set the modes and what must be done in what mode to allow operation of the units via DMX. As an additional note, there is also a way to enter into a TEC setting menu to adjust the pump intensity. We'd prefer that this not be changed unless absolutely necessary but instructions for this are below as well. 1. All settings must be set/checked in the PR7 mode. Once you have put the machine in to PR2 or 3 mode,you can no longer change the DMX addresses, follow addresses, etc. 2. Put your machine in PR7 mode: 1. DMX cable must be disconnected. 2. Turn machine on,while it is starting to scroll through the start-up menu, press and hold MANUAL+SELECT+DOWN (yes all three together), until the screen changes to PRX. 3. As soon as it goes to the PRX screen, release all three buttons 4. Using the UP or DOWN button to scroll to PR7 5. Turn the machine off,wait approximately 5 seconds,turn back on. You are now in PR7 Mode. 6. If your machine was already in PR1 mode, simply turn the machine off and back on 7. In PR7 mode, if a pre-delay is set, there will be a delay in output after the FreezeFog activation 3. Using PR7 Mode: 1. DMX cable must be disconnected 2. SELECT: sequentially cycles through the adjustable controls 1. Smoke level: 0-99%variation, only set if using in manual/PR1 mode 2. Pre-delay: Time in seconds before actual smoke issue-only set if using PR7 or PR2 modes 3. Fan Speed: 0-99% phase control for optional fan control output-only set if using PR7 or PR2 modes 4. Timer On:timer for Smoke issue or select NOT USED 5. Timer Off.timer for interval of non-smoke issue or select NOT USED 6. DMX Address: Selects the base DMX address