Laserfiche WebLink
VERETT <br />0 <br />Permit Number: P2407-029 <br />Applied: 7/19/2024 <br />Issued: 7/22/2024 <br />Status: FINALED <br />Parent Permit: B2404-044 <br />Parent Project: <br />Details <br />NA <br />Permit Inspections <br />City of Everett <br />Approved:7/22/2024 <br />Finaled: 9/16/2024 <br />Description: Plumbing rough & install of break sink and water heater <br />Site Address: 10521 19TH AVE SE STE 101 <br />City, State Zip Code: EVERETT, WA 98208-4262 <br />Applicant: GS (PLUMB) MECHANICAL LLC <br />Owner: ALLIED TELESIS INC <br />Contractor: GS (PLUMB) MECHANICAL LLC <br />SCHEDULED DATE COMPLETED DATE TYPE <br />INSPECTOR <br />RESULT <br />REMARKS <br />8/1/2024 8/1/2024 PLUMB 03-ROUGH <br />JASON <br />CORRECTION <br />see notes <br />IN <br />MORRISSEY <br />REQUIRED <br />Notes: <br />7/31/2024 11:54 AM Pat McDonnell <br />Contact Name: Pat McDonnell <br />Site Address: 10521 19TH AVE SE STE 101 <br />Phone:4258905087 <br />e-Mail: patmcdonnell@hstconstruction.com <br />- Cannot tie relief line discharge together with pan drain per UPC 608.5. Relief line must run independently to termination with an air -gap.- Provide <br />clean out for break sink per UPC 707.4.- Provide seismic support for hot water tank per UPC 507.2. Tank and supporting pan must be stabilized to resist <br />horizontal displacement during a seismic event.- Provide trap primer for hub drain per UPC 1007.1 Primer must be water supplied per UPC 1007.2.- <br />Replace double San tee with double fixture fitting per UPC 706.2. <br />8/6/2024 <br />8/6/2024 <br />PLUMB 03-ROUGH <br />JASON <br />CORRECTION <br />see notes <br />IN <br />MORRISSEY <br />REQUIRED <br />Notes: <br />8/2/2024 9:27 AM Pat McDonnell <br />Contact Name: Pat McDonnell <br />Site Address: 10521 19TH AVE SE STE 101 <br />Phone:4258905087 <br />e-Mail: patmcdonnell@hstconstruction.com <br />- Non directional clean out tees must be installed in vertical position. Clean -out fitting needs to be wye or combo unless installed on the vertical. Per <br />UPC707.5 CleaningEach cleanout shall be installed so that it opens to allow cleaning in the direction of flow of the soil or waste or at right angles thereto <br />and, except in the case of wye branch and end -of -line cleanouts, shall be installed vertically above the flow line of the pipe.- Will confirm trap primer at <br />final. Primer must be listed per UPC 1007.2 Trap Seal PrimersPotable water supply trap seal primer valves shall comply with ASSE 1018. Drainage and <br />electronic design type trap seal primer devices shall comply with ASSE 1044. <br />I <br />Printed: Thursday, 12 December, 2024 1 of 2 rk <br />SUPERION <br />