Laserfiche WebLink
Fig. 828 — TOLCO universal sway brace attachment <br />Function: To attach sway bracing to various types of steel structural members that have a flange <br />thickness between 3/8" and 7/8". The Fig. 828 is the structural attachment component of a longitudinal or lateral <br />swaybrace assembly. It is intended to be combined with a TOLCO'" transitional attachment, "bracing pipe' sized <br />in accordance with the transitional attachment instruction sheet, and a TOLCO "braced pipe" attachment to form a <br />complete bracing assembly. Sway brace assemblies are intended to be installed in accordance with NFPA 13 and the <br />manufacturer's installation instructions. <br />Beam, truss or girder <br />May pivot in <br />any direction <br />Flange thickness UL Rated load <br />3/8" 10901bs <br />Y4"-7/8" 13001bs <br />c �L us FM <br />LISTED APPAUV® <br />Installation Instructions: Slide the Fig. 828 on the flange of the beam, truss, or girder Be sure the attachment is fully engaged to <br />the rear of the opening. Tighten the cone point set screws until the heads break off. Remove the flange nut from the carriage bolt. <br />Install aTOLCO swivel fitting (Fig, 909, 910, 980, *986). Use flange nut to secure the swivel fitting. <br />*Not UT listed when used in combination with Fig. 986 <br />E:T•N <br />Powering Business Worldwide <br />Eaton <br />1000 Eaton Boulevard <br />Cleveland, OH 44122 <br />United States <br />Eaton com <br />13201 Dahlia Street, Suite 200 <br />Fontana, CA92337 <br />United States <br />Phone. 800 851 7415 <br />v2020 Eaton <br />All Rights Reserved <br />Printed in USA <br />Publication No. IL309003EN <br />September 2020 B-Dne Division <br />Eatoncom/tolco <br />Eaton is a registered trademark. <br />All other trademarks are property <br />of their respective owners. <br />Follow us on social media to get the <br />le m at produ of and sup port in b rm a t on. <br />fOwlinjo <br />