Laserfiche WebLink
: Operation <br /> Remote Set-Up <br /> Verify the Switch is on "REMOTE" <br /> The battery holder has a switch built into it (see illustration below). This switch must remain in the <br /> REMOTE position for the remote to operate. <br /> O� <br /> RFMOT� <br /> j <br /> l . <br /> Synchronize the Transmitter to the IFC <br /> The transmitter will need to be synchronized to the IFC (Integrated Fireplace Control) before the remote <br /> will work correctly. Synchronizing is done in the following two steps below (see illustration below): <br /> 1. Press the PRG (Program) button on the battery box(IFC will beep 3 times). <br /> 2. Press the"ON" button on the transmitter(IFC will beep 3 times). <br /> "Beef" "Beep" <br /> 4el <br /> "Beep" ^Beep" <br /> "Beep" "Beep" <br /> I <br /> NOTE: If power is cut off to the IFC for an extended period of time, you may need to re-synchronize the <br /> remote. <br /> Clearing the System Memory <br /> This appliance uses an Integrated Fireplace Control (IFC)to store the unique code for the remote control. <br /> If you wish to clear the system memory, MAKE SURE GAS IS TURNED OFF TO THE APPLIANCE then <br /> press the PRG (Program) button for 10 seconds. The pilot will start to spark repeatedly, signifying all <br /> system memory has been cleared. The system will return to its original configuration: a remote will need <br /> to be synchronized; and, the system will operate under continuous pilot mode. <br /> ©Travis Industries 4/19/23- 1443 Greenfield GSR2 <br />