Laserfiche WebLink
1 Operation <br /> Starting the Stove for the First Time <br /> • Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will <br /> cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This <br /> is normal. We recommend opening a window to vent the room. <br /> • Condensation may appear on the glass each time you start the stove -this is normal. <br /> • Blue Flames will occur on the stove when it first comes on. After fifteen minutes the flames will turn <br /> a more realistic yellow and orange color. <br /> Intermittent/Continuous Pilot <br /> This heater may run with the pilot continuously running or in intermittent mode. For most homeowners, <br /> the intermittent mode is preferred (this saves fuel, doesn't give off un-needed heat). However, in some <br /> situations the homeowner may prefer to switch the heater to continuous pilot. The most typical reasons <br /> for switching to continuous pilot are: <br /> • Very Cold Conditions—in very cold conditions you may notice that the burner does not light quickly, <br /> and the flames lift off the burner. If this is situation, we recommend you switch to continuous pilot. <br /> This will create a slight draft in the vent, allowing for the burner to light quickly and draft correctly. <br /> • Excessive Condensation on Glass After Startup—certain installations may encounter excessive <br /> fogging on the window after startup (not just the first time the heater was started). This is an aesthetic <br /> condition that may be remedied by switching the heater to continuous pilot. <br /> • Cold Glass or Heater Front—in very cold conditions you may notice that the heater front and glass <br /> become very cold. To remedy this, switch the heater to continuous pilot. <br /> • Frequent On/Off Operation —if you are frequently turning the heater on and off, you may wish to <br /> leave it in continuous pilot. This allows the burner to turn on more quickly, without pilot ignition delay. <br /> Switching from Intermittent (IPI) to Continuous Pilot (CPI) <br /> The pilot mode on this appliance is adjusted using the remote. With the remote in the off position <br /> (thermostat off, manual off), follow the directions below to adjust the pilot mode. <br /> ■■■ ■■■°F <br /> M NEW <br /> vPress the"MODE"button <br /> 41t/ when the appliance is off to <br /> adjust the IPI/CPI. <br /> NOTE:This icon appears <br /> when the appliance is in <br /> CPI mode. <br /> Press the"UP"button Press the"DOWN"button <br /> ■■■ ■■■TF to activate CPI mode. ■■■ ■■■oF to activate IPI mode. <br /> : i■: i i■i <br /> v q► <br /> ©Travis Industries 4/19/23- 1443 Greenfield GSR2 <br />