Laserfiche WebLink
50 maintenance (for <br /> qualified service personnel only)Light Replacement <br /> An accent light is included in your stove to provide additional lighting. To replace the bulb, follow the <br /> directions below: <br /> • Disconnect stove from power. Shut off gas to the stove. Make sure the stove is cool before <br /> proceeding (15 minutes). <br /> • Remove the stove top and place it aside (see page 29). <br /> • Remove the four screws securing the accent light cover. Place the cover aside. <br /> • Remove the two screws securing the accent light assembly. Place the assembly upside down on the <br /> firebox top, making sure the wiring is not damaged or dislodged. When replacing, make sure the <br /> glass is aligned below the assembly. <br /> • Loosen the two set screws nearest the bulb to disengage the bulb from the holder. Remove the bulb <br /> from the holder. Replace the bulb, making sure not to touch the bulb with your fingers (grasp the bulb <br /> with the bulb packaging or a paper towel). Tighten the screws until the bulb is secure (do not over- <br /> tighten, this may damage the electrical contacts on the bulb). When the bulb is inserted into the <br /> socket the two posts will be exposed approximately'/" (6mm)—this is normal. <br /> Do not loosen these screws <br /> Micro(1/16")Standard (they hold the wires in place). <br /> or Philips Screwdriver <br /> ©Travis Industries 4/19/23- 1443 Greenfield GSR2 <br />