1916 ROCKEFELLER AVE 2025-03-24 - Laserfiche WebLink

FLASHKIT PRO M FLASHKIT PRO U N I RAC FEATURING()SHED&SEAL TECHNOLOGY INSTALLATION GUIDE FEATURING 0 SHED&SEAL TECHNOLOGY FLASHKIT PRO is the complete attachment solution for composition shingle roofs. Featuring Unirac's patented FLASHKIT PRO IS THE COMPLETE FLASHING AND ATTACHMENT SOLUTION FOR COMPOSITION ROOFS. SHED & SEAL technology, a weather proof system which provides the ultimate protection against roof leaks. Kitted in 10 packs for maximum convenience, flashings and hardware are available in Mill or Dark finishes. ' With FLASHKIT pro, you have everything you need for a quick, professional installation. '' INSTALL FLASHKIT PRO FLASHING INSTALL L-FOOT ATTACH L-FOOTTO RAIL PRE-INSTALL •Drive the lag bolt down until the L-foot is held firmly in place. It is normal for the EPDM on the underside of the stainless steel backed •Locate roof rafters and snap chalk lines to mark the installation EPDM washer to compress and expand beyond the outside edge of point for each roof attachment. the steel washer when the proper torque is applied. •Drill a 7/32"pilot hole at each roof attachment.Fill each pilot hole TIP: with sealant. •Use caution to avoid over-torqueingthe lag bolt if usingan impact driver. STEP INSTALL FLASHKIT PRO FLASHING •Repeat Steps I and 2at each roof attachment point. Add a U-shaped bead of roof sealant to the underside of the flashing STEP 3 ATTACH L--FOOT TO RAIL with the open side of the U pointing down the roof slope. Slide _ the aluminum flashing underneath the row of shingles directly up •Insert the included 3/8"-16 T-bolts into the lower slot on the Rail slope from the pilot hole as shown.Align the indicator marks on the (sold separately),spacing the bolts to match the spacing between lower end of the flashing with the chalk lines on the roof to center the roof attachments. the raised hole in the flashing over the pilot hole in the roof.When installed correctly,the flashing will extend under the two courses of •Position the Rail against the IL-Foot and insert the threaded end of shingles above the pilot hole. the T-Bolt throughthe continuous slot in the L-Foot.Apply anti-seize to bolt threads to prevent galling of the T-bolt and included 3/8" serrated flange nut. Place the 3/8" flange nut on the T-bolt and STEP 2 INSTALL L-FOOT finger tighten.Repeat STEP 3 until all L-Feet are secured to the Rail _ Fasten IL-foot and Flashing into place by passing the included lag with a T-bolt.Adjust the level and height of the Rail and torque each • bolt to 30ft-Ibs. bolt and pre-installed stainless steel-backed EPDM washer through TRUSTED WATER SEAL FLASHINGS YOUR COMPLETE SOLUTION CONVENIENT 10 PACKS the L-foot EPDM grommet,and the raised hole in the flashing,into FEATURING O SHED&SEAL TECHNOLOGY Flashings,lags,continuous slot L-Feet and hardware Packaged for speed and ease of handling the pilot hole in the roof rafter. THE COMPLETE ROOF ATTACHMENT SOLUTION FASTER INSTALLATION. 25-YEAR WARRANTY.