Laserfiche WebLink
<br /> <br />Fulton Street Pedestrian Bicycle Corridor PAGE 105 OF 114 CONTRACT <br />FEDERAL AID # TAP-0420(026) <br />WO #3785 September 6, 2024 <br /> <br />Category 2: Sensitive information <br />RJ 45 Ethernet 1 <br /> 2 <br />ENVIRONMENTAL 3 <br />-34°C to +74°C (-29.2°F to + 165.2°F) 4 <br />0 to 95% relative humidity – non-condensing NEMA TS2 Environmental 5 <br />compliant 6 <br /> 7 <br />A single EDGE card shall communicate with 1 to 8 sensors and include 8 <br />interface to the agencies existing IP network. Only a single IP address should 9 <br />be necessary for all sensors and allow for independent streaming of the 10 <br />thermal video streams by using ports. 11 <br /> 12 <br />The system shall be designed to operate reliably in the adverse environment 13 <br />of roadside cabinets and shall meet or exceed all NEMA TS1 and TS2, as 14 <br />well as Type 170/2070 environmental specifications. 15 <br /> 16 <br />Ambient operating temperature shall be from –34 to +74 degrees Centigrade 17 <br />(-29.2 to +165.2 degrees Fahrenheit) at 0 to 95% relative humidity non-18 <br />condensing. 19 <br /> 20 <br />The system shall be powered by 12-60 VDC or 12-42 VAC. 21 <br /> 22 <br />Surge ratings shall be set forth in the NEMA TS1 and TS2 specifications. 23 <br /> 24 <br />The EDGE interface board shall have 4 opto -isolated open collector outputs. 25 <br />Twenty-four (24) additional outputs shall be available via the USB expansion 26 <br />port and up to five (5) 4 I/O USB expansion modules. 27 <br /> 28 <br />Must be able to provide loop emulation for presence, bike presence, counting 29 <br />and data collection. 30 <br /> 31 <br />Presence hold time must have parameters that range from 10 to 600 seconds. 32 <br /> 33 <br />Each TI BPL2 EDGE card shall allow for up to 24 digital inputs into the traffic 34 <br />controller via the 4 I/O USB Expansion boards or up to 64 digital inputs into 35 <br />the traffic controller via the PIM Module using an SDLC interface. 36 <br /> 37 <br />Each TI BPL2 EDGE card shall have error detection. Outputs will be turned 38 <br />β€œON” if the video signal is bad or the card is not functioning properly. A user 39 <br />defined quality level will automatically put selected outputs to recall in cases 40 <br />of severe degraded visibility (i.e., fog, blizzard, etc.). Normal detection 41 <br />resumes when visibility improves above the user defined thermal quality level. 42 <br /> 43 <br />Using an agencies network, the TI BPL2 Edge card shall be capable of 44 <br />streaming all connected sensors video streams simultaneously via MPEG -45 <br />4/H.264/MJPEG. These streams are available with or without detection 46 <br />overlay. 47