10726 20TH PL W 2025-04-01 - Laserfiche WebLink

RESIDENTIAL PHOTOVOLTAIC PERMIT APPLICATION (Page 1 of 2) CITY OF EVERETT PERMIT SERVICES SUBMITTAL INSTRUCTIONS:Email application to PermilServices@everettwa.gov or drop off at 3200 Cedar Street 2nd Floor Drop Box EVERETT CONTACT INFORMATION:(P)425-257-8810 1(E)PermitServices@everettwa,gov I(W)everettwa,gov/permits WASHINGTON PROJECT SITE INFORMATION PROJECT ADDRESS: 10726 20th PI W,Everett,Washington,98204 PARCEL#: BUILDING TYPE: ❑SFR-DETACHED ❑SFR-ATTACHED 1 TOWNHOUSE ❑DUPLEX CONTACT INFORMATION OWNER NAME: Marvin Wuest CONTRACTOR NAME: BRS Field Ops,LLC CONTRACTOR LIC.#(REQUIRED); BRSFIF0820N3 ICITY OF EVERETT BUSINESS LIC.#(REQUIRED): 60040 PRIMARY CONTACT: ❑OWNER WCONTRACTOR El OTHER(Please Specify) CONTACT NAME: ICONTACT PHONE: 385-482-0045 Diana Sanchez ICONTACT EMAIL: permitting.departmen€@blueravensolar.com SOLAR PANEL APPLICATION INFORMATION PV SYSTEM DESCRIPTION(include manufacturer and model,#of PV modules and inverters): MODULE TYPE:(16)REC Solar REC420AA PURE-R MONITORING:Enphase IQ Combiner 4 X-IQ-AM1-240-4 BUILDING PERMIT CHECKLIST DETERMINE IF YOUR PROJECT QUALIFIES FOR AN OVER-THE-COUNTER BUILDING PERMIT: If you answer yes to all of the below questions, the project qualifies for an over-the-counter building permit. YES NO 1. PV system is designed and proposed for a detached one-or two-family dwelling or townhouse not more than three stories above grade or detached accessory structure that is code compliant to setbacks and height, or code allows Q ❑ expansion of nonconformity for solar modules. [IRC 101.21 2. Modules on pitched roofs do not exceed the highest point of the roof unless approved by the local jurisdition. [� ❑ 3. Rooftop is made from lightweight material such as a single layer of composition shingles, metal roofing, lightweight © ❑ masonry,or cedar shingles. 4.The installation shall comply with the manufacturer's instructions. [IRC M2302.2] 0 ❑ 5. The installation shall meet the requirements of NFPA 70 National Electric Code, and all required electrical permit($)must ❑ be obtained from the Authority having Jurisdiction to administer the electrical code. [IRC M2302.2] 6. The installation shall meet the requiremetns of the International Fire Code as amended by WA State. [IRC M2302.2] ❑ 7.The PV system is designed for the wind speed of the local area, and will be installed per the manufacturer's Elspecifications. [IRC M2302.2.1(1)] B.The ground snow load does not exceed 70 pounds per square foot. [IRC M2302.2A(1)] 8 ❑ 9.The total dead load of modules, supports, mountings, raceways, and all other appurtenances weigh no more than four 0 ❑ pounds per square foot. [IRC M2302,2.1(3)]. Enter total dead load of system (lbsfsq.ft.): 10.To address uplift, modules are mounted no higher than 18"above the surface of the roofing to which they are affixed. D ❑ [IRC M2302.2.1(4)] 11. Supports for solar modules are installed to spread the dead load across as many roof-framing members as needed to © ❑ ensure that no point load exceeds fifty(50)pounds. [IRC M2302.2.1(5)] 12.The photovoltaic modules and supporting structure shall be constructed of noncombustible materials or fire-retardant a ❑ treated wood equivalent to that required for the roof construction. [IRC M2302.2.11 13, Roof and wall penetrations shall be flashed and sealed to prevent entry of water, rodents, and insects. [IRC M2302.2.2] a ❑ 14, PV modules are listed and laveled with a fire classification in accordance with UL 1703. [IRC M2302.2.31 0 El Comments: PLEASE FILL OUT A CITY OF EVERETT BUILDING PERMIT APPLICATION IF YOU QUALIFY FOR AN OTC BUILDING PERMIT. City of Everett Official Use Only ASSOCIATED BUILDING PERMIT P Continue on to Page 2 of Application (Revised 412112022)