Laserfiche WebLink
Hilti PROFIS Engineering 3.0.81 <br /> www.hilti.com <br /> Company: KPFF Page: 6 <br /> Address: SPD Specifier: NAP <br /> Phone I Fax: I E-Mail: <br /> Design: SHEAR WALL HOLDOWN ANCHOR Date: 12/17/2022 <br /> Fastening point: <br /> 4 Shear load <br /> Load V a[lb] Capacity+ V [Ib] Utilization(iv=V A V„ Status <br /> Steel Strength* N/A N/A N/A N/A <br /> Steel failure(with lever arm)* N/A N/A N/A N/A <br /> Pryout Strength(Bond Strength controls)* N/A N/A N/A N/A <br /> Concrete edge failure in direction** N/A N/A N/A N/A <br /> *highest loaded anchor **anchor group(relevant anchors) <br /> 5 Warnings <br /> • The anchor design methods in PROFIS Engineering require rigid anchor plates per current regulations(AS 5216:2021, ETAG 001/Annex C, <br /> EOTA TR029 etc.).This means load re-distribution on the anchors due to elastic deformations of the anchor plate are not considered-the <br /> anchor plate is assumed to be sufficiently stiff,in order not to be deformed when subjected to the design loading.PROFIS Engineering calculates <br /> the minimum required anchor plate thickness with CBFEM to limit the stress of the anchor plate based on the assumptions explained above.The <br /> proof if the rigid anchor plate assumption is valid is not carried out by PROFIS Engineering. Input data and results must be checked for <br /> agreement with the existing conditions and for plausibility! <br /> • Condition A applies where the potential concrete failure surfaces are crossed by supplementary reinforcement proportioned to tie the potential <br /> concrete failure prism into the structural member.Condition B applies where such supplementary reinforcement is not provided,or where pullout <br /> or pryout strength governs. <br /> • Design Strengths of adhesive anchor systems are influenced by the cleaning method. Refer to the INSTRUCTIONS FOR USE given in the <br /> Evaluation Service Report for cleaning and installation instructions. <br /> • For additional information about ACI 318 strength design provisions, please go to https://submittals.us.hilti.com/PROFISAnchorDesignGuide/ <br /> • Installation of Hilti adhesive anchor systems shall be performed by personnel trained to install Hilti adhesive anchors. Reference ACI 318-14, <br /> Section 17.8.1. <br /> Fastening meets the design criteria! <br /> Input data and results must be checked for conformity with the existing conditions and for plausibility! <br /> PROFIS Engineering(c)2003-2022 Hilti AG,FL-9494 Schaan Hilti is a registered Trademark of Hilti AG,Schaan <br /> 6 <br />