Laserfiche WebLink
5.2 Operating Instructions <br /> FOR YOUR SAFETY READ BEFORE OPERATING <br /> AWARN I NG If you do not follow these instructions exactly, a fire or explosion <br /> may result causing property damage, personal injury or loss of life. <br /> A. This appliance does not have a pilot. It is If you cannot reach your gas supplier, call <br /> equipped with an ignition device which automat- the fire department. <br /> ically lights the burner. Do not try to light the <br /> burner by hand. C. Use only your hand to push in or turn the gas <br /> control valve. Never use tools. If the gas <br /> B. BEFORE OPERATING, smell all around the control valve will not turn by hand, do not try <br /> appliance area for gas. Be sure to smell next to to repair it, call a qualified service technician. <br /> the floor because some gas is heavier than air Force or attempted repair may result in a fire or <br /> and will settle on the floor. explosion. <br /> WHAT TO DO IF YOU SMELL GAS D. Do not use this appliance if any part has been <br /> • Do not try to light any appliance. under water. Immediately call a qualified ser- <br /> • Do not touch any electric switch; do not use vice technician to inspect the appliance and to <br /> any phone in your building. replace any part of the control system and any <br /> • Immediately call your gas supplier from a gas control which has been under water. <br /> neighbor's phone. Follow the gas supplier's <br /> instructions. <br /> OPERATING INSTRUCTIONS <br /> 1. STOP! Read the safety information above. you smell gas, STOP! Follow"B" in the safety <br /> 2. Set the temperature controller to lowest setting. information above. If you don't smell gas, go to <br /> 3. Turn off all electric power to the appliance. the next step. <br /> 4. This appliance does not have a pilot. It 7. Turn the manual gas valve located at gas inlet <br /> is equipped with an ignition device which of appliance counterclockwise to the full ON <br /> automatically lights the burner. Do not try to position. 1'� <br /> light the burner by hand. 8. Turn on all electric power to the appliance. <br /> 5. Turn the manual gas control valve located at 9• Set the temperature controller to desired <br /> gas inlet of appliance clockwise to the OFF setting. <br /> position. 10. If the appliance will not operate, follow the <br /> 6. Wait five (5) minutes to clear out any gas. instructions"To Turn Off Gas To Appliance" and <br /> Then smell for gas, including near the floor. If call your service technician or gas supplier. <br /> Manual Valve <br /> CLOSE OPEN <br /> TURN OFF GAS TO APPLIANCE <br /> 1. Set the temperature controller to lowest setting. 3. Turn the manual gas control valve located at <br /> gas inlet of appliance clockwise to the OFF <br /> 2. Turn off all electric power to the appliance if position. <br /> service is to be performed. <br /> Rinnai Tankless Water Heater Installation and Operation Manual 72 <br />