105 FERN RD 2025-03-24 - Laserfiche WebLink

' Installation • qualified installers only) Electrical Requirements Travis Industries manufactures an "Insert Wiring Kit"for this insert (sku 97200315). This kit allows installers to wire 120 volt AC power into a fireplace directly to the insert, eliminating the need for an external power cord. • Plug the power cord into a grounded 120 Volt outlet(do not remove the grounding pin). • The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1. • Do not route the power over the appliance or near any hot or moving components. Re-Routing the Power Cord to the Front of the Insert The power cord is shipped attached to the side of the insert. It may be routed to the front where it exits behind the face but in front of the surround panel. See the directions below for details. O Remove the side O O access panel. Disconnect the Route wires through the "- molex connection bracket. and remove the Use pliers to front mountingreinstall the Reinstall the / power cord. access panel / strain relief. 00 00 0/ Reconnect the ® molex connection. Use pliers to remove the strain relief. Using the Insert Wiring Kit See the instructions included with the wiring kit for attaching the kit to the side of the insert. O Remove the side O access panel. C Disconnect the molex connection and remove the power cord. 01 O Reconnect the Molex connector 00 and replace the access panel. C �; e Use pliers to remove the strain relief. Attach the hard wire kit to insert(see kit instructions for details). ©Travis Industries 4/26/2023- 1558 430 MF GSR2