Laserfiche WebLink
Installation / I • installers <br /> Vent Requirements <br /> Travis Industries manufactures a vent kit specifically for this insert (sku 96200339). <br /> It includes 30' (10M)of vent, hose clamps, and a high wind cap. The flashing on �� ,`� <br /> tit <br /> the cap is 18" (458mm) by 18" (458mm). <br /> Travis Industries manufactures a vent kit specifically for this insert (sku 96200330). <br /> It includes 30' (10M)of vent, hose clamps, and a prairie cap. The flashing on the — - <br /> cap is 18" (458mm) by 18" (458mm). <br /> • The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to <br /> a chimney serving a separate solid fuel or gas-burning appliance. Each direct vent gas appliance must use its own <br /> separate vent system. <br /> • Make sure the exhaust pipe on the heater connects to the exhaust portion of the cap. The illustrations below show <br /> how the flex liners should be attached. <br /> • The exhaust vent must reline the entire length of the chimney and terminate above the chimney top. <br /> • Be careful not to crimp or rupture the liner when bending it into chimney offsets. <br /> • When installed, the vent must meet all of the vent manufacturer's requirements. <br /> • Use the following vent: <br /> 3" UL 441 or 1777 Gas Liner for Exhaust, 3" UL 441 or 1777 Gas Liner for Air Inlet <br /> Duravent 6-5/8"to 3" Co-Linear Adapter and Flashing (46DVA-Gk) <br /> Duravent High-Wind Vertical Termination (46DVA-VCH)for high-wind applications or Prairie Cap <br /> Li Li <br /> Max.Ht.40'(12.2M) <br /> Min.Ht.16'(4.9M) <br /> Max.4' <br /> (1.2M) <br /> offset <br /> Drafting Performance <br /> This direct vent appliance requires natural draft to operate (similar to a wood stove or other heating appliance). Draft <br /> can be adjusted using the included restrictor. The restrictor settings detailed in the manual should be followed <br /> (variations may occur depending upon installation parameters). <br /> Many factors may negatively influence the draft of the appliance. Travis Industries will not be responsible for improper <br /> draft due to factors such as trees, hills, buildings, obstructions, excessive wind, extreme hot or cold outdoor <br /> temperatures, restrictive vent terminations, or influence from mechanical systems. <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />