Laserfiche WebLink
• Finalizingthe Installation <br /> Steps for Finalizing the Installation <br /> 1. Remove the glass (see page 22). <br /> NOTE: If using propane (LP) convert the appliance prior to installing the media. <br /> 2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be <br /> detected once it enters the firebox, ensuring gas does not build up. <br /> 3. Install the four AA batteries (see illustration below). The AA batteries act as a power backup in case <br /> the household (AC) power goes out and are required for operation. Install three AAA batteries into <br /> the remote (see illustration below). Synchronize the transmitter to the IFC (see page 30). <br /> 4. Make sure the accent light bulbs are in place and work correctly. <br /> NOTE: Take care to not touch the bulb with your fingers—use a cloth or paper towel). <br /> 1 8agecy'; <br /> P�ea�acl 0ae� <br /> m Pp9a�eN ea�ecl <br /> O <br /> • <br /> 5. Install the media (see the instructions included with the media kit). <br /> 6. Replace the glass. <br /> 7. Start the heater. <br /> 8. Leak test all gas joints. <br /> 9. Adjust the air shutter following the directions on the next page. <br /> 10. Attach the face following the directions included with the face. <br /> 11. Adjust the flame to its highest position -the flames should not contact the top of the firebox. Check the flame <br /> on low position. The flames should burn off of each burner hole. If the heater does not work correctly, <br /> contact your Travis dealer for a remedy. <br /> 12. Give this manual to the homeowner for future reference and fully explain the operation of this heater. <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />