Laserfiche WebLink
Optional Equipment (for qualified installers only) • <br /> Embers and EG Glass (Optional) <br /> 40W d <br /> ARNINGS <br /> • Do not allow the glass or rock material to block the air slots or to become too thick (maximum 1 <br /> laver deep on the burner). Failure to properly install the Rock Ember material may lead to <br /> sooting and poor performance. <br /> • Make sure the gas control valve is OFF and the heater is cool prior to conducting service. <br /> • If using propane (LP), convert the appliance before installing the media <br /> • This appliance requires the use of a fireback kit. Install the Fireback BEFORE installing the <br /> media. <br /> Overview <br /> This kit comes with ember glass (4lbs) and (2)sizes of ember material (1/2 lb. of small rocks and 4 lbs of <br /> large rocks). Because this kit includes more media than needed, we recommend keeping the extra glass <br /> and rock media for future use. <br /> Amount of Media Needed: <br /> • Ember-Glo Glass- 3 lbs. (approximately 3 cups). <br /> • Small Rock- 1/3 lbs. (approximately 1 cup). <br /> • Large Rock-3 lbs. (approximately 8 cups). <br /> Installation Notes <br /> • Discard rock at the bottom of the bag that has disintegrated (turned to small, sand-like material). <br /> • Put down the EG glass first. Cover the entire media tray with EG Glass (Do not cover the burner). <br /> • Put down the large rock next. Cover the EG glass with large rock. <br /> NOTE: Do not place large rocks over any burner ports (This will cause sooting). <br /> • Place one layer of small Ember Rock over the burners. <br /> • Do not stack media in piles that may fall over or block airflow. <br /> Ak <br /> F "t <br /> 4 <br /> ©Travis Industries 4/26/2023- 1558 430 MF GSR2 <br />