Laserfiche WebLink
Installation Dimensions and Cover Plate Information <br />Min. to Max. <br />Min. to Max. <br />Cover Plate <br />Recommended <br />Cover Plate <br />Face of Fitting <br />Dropped <br />Cover Plate <br />Cover Plate <br />Diameter <br />Bole Diameter in <br />` <br />Adjustment <br />to <br />Deflector <br />Temperature <br />Model <br />Inch <br />Ceiling <br />Inch <br />Ceiling0) <br />Distance <br />Rating <br />(mm) <br />Inch <br />(mm) <br />Inch <br />below Ceiling <br />�F <br />(mm) <br />(mm) <br />Inch <br />(*C) <br />mm <br />G5 <br />3-5/16 <br />(84) <br />2-5/8 <br />(67) <br />3/4 <br />(19) <br />1-1/2 to 2-1/4 <br />(38 to 57) <br />1/4 to 1 <br />(6 to 25) <br />135°F(3) <br />(57°C) <br />or <br />G5 QR Gasket(2)(94) <br />3-11/16 <br />G5 SR Gasket12) <br />4 <br />(101 mm) <br />165°F(4) <br />(74°C) <br />Notes: <br />1. Face of fitting to ceiling dimensions are based on nominal thread make up. Verify dimensions based on fitting and thread sealing method <br />prior to installation. A 1/2" x 1/2" brass nipple extension (Reliable P/N 6999991900) is available to assist with replacement of Reliable Model <br />G4A sprinklers. <br />2. Model G5 QR Gasket and Model G5 SR Gasket cover plates are sold as assembled units including both the cover plate and gasket. Model <br />G5 QR Gasket and Model G5 SR Gasket cover plates and gaskets are not interchangeable. <br />3. For use with 165°F (74°C) temperature rated sprinklers where the Maximum Ceiling Temperature does not exceed 100°F (38°C). <br />4. For use with 212°F (100°C) temperature rated sprinklers where the Maximum Ceiling Temperature does not exceed 150'F (66°C). <br />Cover Plate Finishes'>(2) <br />Standard Finishes <br />Special Application Finishes <br />White Paint <br />Off -White Paint <br />Chrome'=, <br />Black Paint <br />Custom Color Paint (Specify)(3) <br />Raw Brass (Lacquered) <br />Bright BrassM <br />Finished Bronze (4� <br />Satin Chrome (1) <br />Stainless Steel Clad(5) <br />Custom Printed <br />Notes: <br />1. Paint or any other coating applied over the factory finish will void all <br />approvals and warranties. <br />2. Cover plates do not carry corrosion resistant listings or approvals. <br />3. Custom color paint is semi -gloss unless specified otherwise. <br />4. Not listed for use with QR sealing gasket. <br />5. Stainless steel clad cover plates are Type 316 Stainless Steel on the <br />finished side and C102 Copper Alloy on the back side. <br />Application <br />Model G5 series sprinklers are standard coverage, flat plate <br />concealed pendent sprinklers. The sprinklers are intended for <br />use in accordance with NFPA 13 and FM Global Property Loss <br />Prevention Data Sheets, as well as the requirements of the <br />applicable approval agencies. <br />Model G5 series sprinklers are available as either Quick -response <br />(QR) or Standard -response (SR) depending on the approval <br />agency and cover plate selected. <br />Model G5 series sprinklers use Model G5 flat cover plates. Model <br />G5 QR Gasket and G5 SR Gasket cover plates are available to <br />limit air and dust movement through the ceiling. <br />Bulletin 034 <br />April2023 <br />Listing & Approval Agencies <br />Individual Model G5 series sprinkler may be listed or approved by <br />the following agencies: <br />• Underwriters Laboratories, Inc. and UL Canada (cULus) <br />Listing Category: Sprinklers, Automatic and Open <br />Guide Number: VNIV <br />• FM Approvals (FM) <br />• Loss Prevention Certification Board (LPCB) <br />• VdS SchadenverhUtung GmbH (VdS) <br />• EC -Certificate of Conformity 0832-CPD-2062 (CE) <br />• UKCA EN12259-1 : 1999 +A3:2006 <br />See Table A and the individual sprinkler data sheets in this Bulletin <br />for listings and approvals applicable to each sprinkler. <br />Installation <br />Model G5 series sprinklers are intended to be installed in <br />accordance with NFPA 13, FM Global Property Loss Prevention <br />Data Sheets, and the requirements of applicable authorities <br />having jurisdiction. Model G5 series sprinklers must not be <br />installed in ceilings with positive pressure in the space above. <br />Ensure that the 4 slots in the cup are open and unobstructed <br />following installation. <br />Model G5 series sprinklers are shipped with a wrench -able <br />protective cap that should remain on the sprinkler until the <br />sprinkler system is placed in service following construction. <br />Model G5 series sprinklers can be installed without removing <br />the wrench -able protective cap using the Model W3 wrench. <br />Alternatively, Model G5 series sprinklers can be installed using <br />the Model FC wrench by temporarily removing the protective cap <br />during installation of the sprinkler. The use of any other wrench <br />to installed Model G5 series sprinklers is not permitted and may <br />damage the sprinkler. <br />Page 8 of 9 <br />www.reliablesprinkler.com <br />