1200 INDUSTRY ST 2025-03-24 - Laserfiche WebLink

F. Installer/Applicator/Erector: Contractor or another entity engaged by Contractor as an employee, Subcontractor, or Sub-subcontractor, to perform a particular construction operation, including installation, erection, application, and similar operations. 1. Using a term such as "carpentry" does not imply that certain construction activities must be performed by accredited or unionized individuals of a corresponding generic name, such as "carpenter." It also does not imply that requirements specified apply exclusively to tradespeople of the corresponding generic name. 1.05 CONFLICTING REQUIREMENTS A. General: If compliance with two or more standards is specified and the standards establish different or conflicting requirements for minimum quantities or quality levels, comply with the most stringent requirement. Refer uncertainties and requirements that are different, but apparently equal, to Consultant/ Designer for a decision before proceeding. B. Minimum Quantity or Quality Levels: The quantity or quality level shown or specified shall be the minimum provided or performed. The actual installation may comply exactly with the minimum quantity or quality specified, or it may exceed the minimum within reasonable limits. To comply with these requirements, indicated numeric values are minimum or maximum, as appropriate, for the context of requirements. Refer uncertainties to Consultant/Designer for a decision before proceeding. 1.06 DELEGATED DESIGN A. Performance and Design Criteria: Where professional design services or certifications by a design professional are specifically required of Contractor by the Contract Documents, provide products and systems complying with specific performance design criteria indicated 1. If criteria indicated are not sufficient to perform services or certification required, submit a written request for additional information to Consultant/Designer. 1.07 SUBMITTALS A. Qualification Data: For testing agencies specified in Section 014000 - "Quality Assurance" Article to demonstrate their capabilities and experience. Include proof of qualifications in the form of a recent report on the inspection of the testing agency by a recognized authority. B. Delegated-Design Submittal: In addition to Shop Drawings, Product Data, and other required submittals, submit a statement, signed, and sealed by the responsible design professional, for each product and system specifically assigned to Contractor to be designed or certified by a design professional, indicating that the products and systems are in compliance with performance and design criteria indicated. Include list of codes, loads, and other factors used in performing these services. C. Schedule of Mockups, Tests, and Inspections: Prepare in tabular form and include the following within 30 calendar days after the Notice to Proceed. Failure of Contractor to submit this information may result in PROLOGIS, L.P. withholding the monthly progress payment(s): 1. Specification Section number and title. 2. Description of mockup, test, and inspection. 3. Identification of applicable standards. 4. Identification of test and inspection methods. 5. Number of tests and inspections required. 6. Time schedule or time span for tests and inspections. 7. Entity responsible for performing tests and inspections. 8. Requirements for obtaining samples. 9. Unique characteristics of each quality-control service. D. Project Quality Control/Quality Assurance Plan: Prepare a written and/or graphical plan that includes the following within 30 calendar days after the Notice to Proceed. Failure for Contractor to submit this information may result in PROLOGIS, L.P. withholding the monthly progress payment(s): 1. Project organization SEA00511 / Prologis - SEA00511 01 4000 - 2 QUALITY REQUIREMENTS - FY24- Everett 1 - Capital Roofing Project