Laserfiche WebLink
C <br /> 2. Drilling a wall hole and installing wall embedded pipe <br /> A WARNING <br /> For metal frame or metal board walls, be sure to use a wall embedded pipe and wall hole cover in the feed-through hole to <br /> prevent possible heat,electric shock, or fire. <br /> • Be sure to caulk the gaps around the pipes with caulking material to prevent Wall embedded <br /> condensation, pipe Inside—I-0—Outside <br /> (field supply) ���� Caulking <br /> 1) Drill a feed-through hole with a i 2-9/16 inch (65mm) (for 09/12 class), �/',21 <br /> (field supply) <br /> L� <br /> (1)3-1/8 inch (80mm) (for 15/18/24 class) diameter through the wall at a <br /> downward angle toward the outside. <br /> 2) Insert a wall embedded pipe into the hole. Wall hole cover► <br /> 3) Insert a wall hole cover into wall pipe. (field supply) 2 s/ts" <br /> 4)After completing refrigerantpiping, and drainpiping, caulk the pipe 09/12 class (ssmm) <br /> P 9 9 wiring, P�P <br /> hole gap with putty. to sa03 1/8 <br /> class (880mm0mm <br /> ) <br /> 3. Installing the indoor unit <br /> In the case of bending or curing refrigerant pipes, keep the following precautions in mind. <br /> Abnormal sound may be generated if improper work is conducted. <br /> • Do not strongly press the refrigerant pipes onto the bottom frame. <br /> • Do not strongly press the refrigerant pipes on the front grille,either. <br /> 3-1. Right-side, right-back, or right-bottom piping <br /> 1) Attach the drain hose to the underside of the refrigerant pipes with <br /> adhesive vinyl tape. Right-side piping <br /> 2) Wrap the refrigerant pipes and drain hose together with©insulation <br /> tape. Remove pipe port \Right-back piping <br /> P cover here for Right-bottom <br /> right-side piping. piping Bind refrigerant <br /> pipe and drain <br /> Remove pipe port cover hose together with <br /> here for right-bottom piping. ()insulation tape. <br /> 3) Pass the drain hose and refrigerant pipes through the wall hole,then set \()Mounting plate <br /> the indoor unit on the®mounting plate hooks by using the Q markings � <br /> at the top of the indoor unit as a guide. I <br /> 4) Open the front panel(Refer to"Installation Tips"on page 10), then open <br /> the service lid (Refer to"Indoor Unit Installation Diagram"on page 4). Rang indoor unit on the hooks of <br /> 5) Pass the inter-unit wire from the outdoor unit through the feed-through mounting plate. <br /> wall hole and pass to the front of indoor unit from the back.Then pull <br /> —QQ Mounting <br /> them at front side.Bend the ends of cable tie wires upward for easier When stripping the plate <br /> work in advance. ends of inter-unit wire Inter-unit <br /> 6) Press the bottom frame of the indoor unit with both hands to set it on the madvance,withta ethewire wire <br /> lead ends with tape. <br /> ®mounting plate hooks.Make sure the wire leads do not catch on the Wire guide <br /> edge of the indoor unit. <br /> ■English 6 <br />