8823 7TH AVE SE 2025-04-18 - Laserfiche WebLink

B2302-103 8823 7th Ave SE LANTEYELDERU DAWIT A/JIRU ADDIS D Architectural 1. Bathing facilities in the form of bathtub or shower need to be provided to the Adult Family Home (AFH) portion of the house. If a shower stall is provided, the minimum size of the stall needs to be 30 inches deep by 48 inches long. Grab bars should be installed according to R325.8. See IRC Section 325.1, WAC 51-51-0325 Section R325-Adult family homes R325.8, R325.8.4, R325.8.5, and R325.11. 2. The floor plans need to show that the egress windows'sill height is not greater than 44 inches from the finished floor on the interior. Please annotate egress windows' sill heights in the floor plan on Sheet A-2.1. IRC R310.2.3. 3. As the garage space is proposed to have a change of use from garage to AFH, the only egress door available to the AFH, which is the existing exterior door on the west side connecting the living room to the outside ramp, needs to be shown to meet the requirement of egress door. IRC Section R311.1 and R311.2. 4. The landing outside the abovementioned egress door needs to be shown not less than 36 inches measured in the direction of travel. The slope of the landing shall not exceed 2 percent. IRC R311.3. 5. The ramp on the west side of the house needs to be shown to comply with the maximum slope and landing requirement according to IRC R311.8.1 and R311.8.2. Handrails for the ramp needs to be installed on both sides of the ramp between the slope of 1:12 to 1:20. WAC51-51-0325 R325.9, R325.9.1. 6. Please classify each sleeping room in the AFH according to WAC51-51-0325 R325.3. 7. The locking devices and door activation of the AFH need to follow WAC51-51-0325 R325.4. Please annotate it on the plan. 8. The new tankless water heater needs to be installed per the manufacturer's installation manual and be inspected by the mechanical inspector. Energy &Whole House Ventilation 9. The application proposes to obtain 1.5 credits through ductless mini-split heat pump system, zonal control. Please show the location and efficiency of the system's outdoor condenser unit and indoor heads. This review has been performed for general compliance with the building codes as adopted and amended by the state of Washington and the city of Everett. Corrections and comments made during the review process do not relieve the project from compliance with code and permit requirements. The designers-of-record are responsible for a complete design in accordance with the laws of the state of Washington. 3200 Cedar Street © 425.257.8810 O permitservices@everettwa.gov Everett,WA 98201 425.257.8857 fax everettwa.gov/permits Page 2 of 3