Laserfiche WebLink
EJS Engineering, PLLC 20230828BE EJS_DSchrader_Special Interest Autobody Roof-Calcs <br /> Eric J.Sniezak, P.E. <br /> 183 Mountain View Dr <br /> Packwood, WA 98361 <br /> (360)880-0524/(253)405-2200 <br /> EJS ENGINEERING, PLLC <br /> Scope of Work <br /> EJS Engineering, PLLC was asked to provide structural calculations and structural plans to the <br /> designer/architect/owner/contractor for use in obtaining a building permit for the referenced project <br /> at the referenced location. <br /> The application and use of these calculations is limited to a single site referenced <br /> on the cover sheet. The attached calculations may or may not apply to other sites and <br /> the designer/architect/owner/contractor assumes all responsibility and liability for sites not <br /> expressly reviewed and approved. Please contact EJS Engineering PLLC for use at other sites. <br /> The scope of this agreement covers the design phase only. If site inspections are required by the <br /> building department, these will be performed at an additional hourly fee of$150.00 per hour <br /> (including travel time). Also, revisions to the original design will be billed at the hourly rate of <br /> $150.00 per hour-including site visits and travel time due to construction not following original <br /> engineering. <br /> EJS Engineering PLLC will use that degree of care and skill ordinarily exercised under similar <br /> circumstances by members of the engineering profession in this locale. No other warranty, either <br /> expressed or implied is made in connection with our rending of professional services. For any <br /> dispute, claim, or action arising out of this design, EJS Engineering shall have liability limited to the <br /> amount of the total fee received by EJS Engineering. <br /> All work done by EJS Engineering, PLLC is valid only for the specific project invoiced. Unless <br /> otherwise noted, payment for services are due at delivery. Failure to pay for services rendered will <br /> result in the invalidity of the professional stamp and will be reported to the proper state/county/city <br /> jurisdiction. <br /> Questions about the attached information should be addressed to EJS Engineering, PLLC <br /> Eric J. Sniezak, P.E. <br /> EJS Engineering, PLLC <br /> P.O. Box 511 <br /> Packwood, WA 98361 <br /> (360)880-0524 or (253)405-2200 <br /> eric _ejs-engineering.com <br /> Scope of Work 2 of 7 <br />