1509 CALIFORNIA ST DAWSON PLACE 2025-04-07

Operable ns MODEL 3030 STACKARRANGEMENTS K II rTF rM Standard Center Stack " Y U Panels are conveniently stored at one or 3- both ends and stacked on-center to the wall's installed position. Stack Depth Stack Depth* Pocket Width** The overall depth of the stack area,as required for panel The width of the pocket is determined by the widest panel in the storage,is dictated by the total number of panels in the wall wall run.For specification purposes,assume that the widest panel system.KWIK-WALL's Model 3030-Steel Panels require is 4'-0"(122 cm)maximum.Wall systems that utilize Automatic 43/8"[111.]per panel.To determine the stack depth,calculate type bottom seals will require extra pocket width to allow clearance as follows: for the actuator that protrudes from the bottom of the lead panel. Pocket width may be calculated as follows: Number of Panels x 43/s"fill] If Adjustable or Operable Bottom Seals are specified: Widest Panel+7"[i78] *Note: Additional stack depth is required for wall systems (allows 31/2"[89]for hand clearance on each side) containing the following type of panels: I Automatic Bottom Seals are specified: Expander Panel Closure or Pass Door Panel:3/4"[191 Hinged Panel(s)Closure:4"[102] Widest Panel+to"[254] Pocket Door(s):6"[1521 (for actuator clearance on one side) **Note: For wall systems that include Pocket Doors,please plus reference KWIK-WALL's'3000 Series Pocket Door"brochure for pocket layout dimensions and applications. 3112"[89] (for hand clearance on the other side) FINAL CLOSURE SYSTEMS STANDARD OPTIONAL Standard Expander Panel Closure 1 s 2 3 6 8 The final closure panel is equipped with an expander saddle located on the vertical edge of the panel that mechanically telescopes outward to create a positive contact seal with a rigid wall,pocket door or jamb.The expansion of the " expander saddle is activated by inserting a wrench into an escutcheon plate located on the panel face.The expander panel is equipped with a flush pull handle and an adjustable bottom seal(standard)or(optional)operable bottom seal. Optional Hinged Panel Closure � STANDARD OPTIONAL (Single or Double) jF[M s s 2 3 6 8 This final closure configuration is accomplished by a(single)half panel which is hinged permanently and directly to a structural wall(as shown at right).The _ _—_—_ _—_—_—_ _—_—_—_ ___—_— double version includes a second panel that is hinged to the half panel.The closure panel(s)features an adjustable bottom seal(s)and includes a flush pull handle on each side of the panel. 10 Dimensions in[1 are millimeters.Contact your local distributor for additional assistance or visit www.kwik-wall.com 04-23