Laserfiche WebLink
3 <br />Existing <br />- <br />a. Provide a separate plan for the existing conditions <br />Conditions <br />and include the following: <br />Figure <br />• Label all structures (e.g., oil/water <br />separators, oil stop valve, containment vault, <br />• Done <br />closed or open grate CB). <br />• Indicate where the roof and canopy <br />• The roof drain lines are connected to the <br />downspouts tie into the system. <br />existing fuel island CBs and called out at the <br />Include flow arrows or topographic <br />structures. <br />information as needed to indicate the direction of <br />• Done <br />flow onsite. <br />• Show the outfall pipe and discharge <br />• Out fall is shown along the westerly <br />location. <br />property line and goes under the existing <br />b. Provide a separate figure showing the existing plan <br />building. Notes added to plan. <br />with catchment areas highlighted to show which areas <br />flow to each catch basin. <br />Done <br />4 <br />Project <br />- <br />a. Revise the proposed plan to include the following: <br />Conditions <br />. Label all structures e. <br />( g., oil/water separator, <br />• Done oil stop valve will be removed <br />p <br />Figure <br />oil stop valve, containment vault). <br />from the structure after storm pipe <br />• Include flow arrows or topographic <br />reconfiguration in final design. <br />information as needed to indicate the <br />• Done <br />direction of flow onsite. <br />• Indicate where the roof and canopy <br />• All observed pipes are called out at the <br />downspouts tie into the system. <br />existing CBs <br />• Show the outfall pipe and discharge location. <br />• Added callout for clarity. <br />• Indicate the amount of replaced hard surfaces. <br />. Only replaced hard surface is for the <br />b. Provide a separate figure showing the proposed plan <br />storm/sewer pipe installation. <br />with catchment areas highlighted. <br />Done <br />Page 7 of 10 <br />