7301 HARDESON RD SEPA 017 - 007 AND DIST 1705 - 006 - FED EX BUILDING Land Use Decision Documents 2025-04-21

PUBLIC WORKS .err Stormwater Management Manual for Western Washington, as amended in December 2014, which has been adopted as the City of Everett's Stormwater Management Manual. The City may retain consultants at the applicant's expense to assist the review of the analysis and design of the regional infiltration facility and/or conduct site evaluations which are outside the range of staff expertise. 10. If construction design for this building includes some type of common kitchen facilities other than an employee break/lunch room, then applicable Industrial Pretreatment (IPT) requirement may be triggered under the grease control ordinance. The applicant is encouraged to obtain a copy of the Ordinance and determine applicable requirements prior to building permit application. 11. This project will be subject to Transportation Mitigation in accordance with Ordinance 3387-14 (codified as EMC 18.40) and subsequent revision. The applicant is encouraged to obtain a copy of the Ordinance and determine applicable mitigation fees and/or other requirements prior to building permit application. The actual charges and requirements shall be as per the information on the approved plans at the time of building permit issuance and the ordinance in effect at that time. 12. Provide frontage improvements as needed along the entire project frontage for roadway, pedestrian, and bicycle improvements. This includes replacing any improvements damaged during construction, replacing improvements in poor condition, and any work required for curb cuts and/or utilities. 13. The access to the site requires a traffic control device in the form of a stop sign. 14. All roadways and driveways must meet City of Everett Design Standards. 15. The access point is a private roadway. Use City of Everett standard driveway plans (Design and Construction Standard Drawing#315, 316, or 317, as applicable based on grades). 16. Commercial driveways for industrial sites may have radiuses instead of a standard driveway apron to support the necessary width for truck access. In order to allow radiuses or a driveway width wider than 35', engineering justification (AutoTurn Analysis or similar) is required. Without justification, the maximum driveway width shall not exceed 35'. 17. Parking layout must be consistent with city of Everett Standards (Standard Drawing# 340) and will be reviewed during the Building Permit/Public Works Permit review period. 18. Special charges for connection to the sewer and water systems in accordance with Ordinance 3095-08 (codified as EMC 14.08.135) and subsequent revision are applicable. These charges are based on projected water usage and can be substantial. Applicant is encouraged to obtain a copy of the Ordinance and determine estimated charges prior to building permit application. The actual charges shall be computed by the Public Works Department per the ordinance in effect at the time and according to the information on the approved plans at the time of building permit issuance. Page 2 of 2