Laserfiche WebLink
2018 WSEC Requirements for Commercial Buildings including Group R2, R3 & R4 over 3 stories & all R1 -- Administered by 02024 NEEA, All rights reserved <br />The following information is necessary to check a permit application for compliance with the lighting systems, motors and electrical system requirements in the <br />Washington State Energy Code, Commercial Provisions. <br />For questions about this report, contact WSEC Commercial Technical Support at 360-539-5300 or via email at com.techsupport@waenergycodes.com <br />C'405.6 <br />Electrical <br />Include electrical transformer schedule of <br />transformers <br />electrical plans: indicate transformer type_ <br />size, efficiency. or exception taken <br />YES C405.11 <br />Feeders and branch <br />Provide documentation that demonstrates <br />circuits <br />maximum voltage drop across feeders and <br />branch circuits does not exceed 5% <br />C'405.7 <br />Dwelling trait <br />Indicate on electrical plans that each dwelling <br />electrical ener% <br />unit in Group R-_' has a separate clect ical <br />consumption <br />energy meter <br />C405.8 <br />Electric motor <br />Include all motors, including fractional hp <br />efficiency <br />motors, in electric nlolor schedule on <br />electrical plans: indicate motor type. <br />horsepower, rpm. rated efficiency, or <br />exception applied <br />C405.9.1 <br />Elevator cabs <br />For luminaires in each elevator cab. pro%ide <br />calculations that demonstrate average eificacv <br />is not less than 35 lumens per watt <br />For elevators that do not have an integral air <br />conditioning system. indicate rated watts per <br />cfm for elevator cab ventilation fans do not <br />exceed 0.33 watts per cfnl <br />Indicate automatic controls that dc-energize <br />lighting and ventilation fans when elevator is <br />stopped and unoccupied for a period of 15 <br />minutes or more <br />C405.9.2 <br />Escalators and <br />hldicate escalators comply with ,ASME <br />nlovint'' WAS <br />A 17. I/CSA 1344: automatic controls are <br />configured to reduce operational speed to the <br />Illillilllnlll pC1711ltted when not In use <br />Ca <br />Regeneratiy e drive <br />Indicate all one-wav down or reversible <br />escalators are provided "ith a variable <br />I requencv regenerative. drive <br />DOCUMENTATION AND SYSTEM REQUIREMENTS TO SUPPORT COMMISSIONING (CX) <br />l 406.4 <br />ac')frc "I 1Iuclrical <br />Indicate that all electrical systems <br />power and lighting <br />(receptacles. transformers, motors, vertical <br />systemS <br />and horizontal transportation) for which the <br />commissioning <br />WSEC requires control functions and / or <br />configuration to perform specific functions <br />are required to be commissioned <br />C405.13 <br />Commissioning <br />C408.1.1 <br />requirements in <br />C408.1.2 <br />construction <br />C408.1.4.2 <br />documents <br />C 103,6.3 <br />Where total building lighting load is > 20 kW. <br />Of- where total lighting load of luminaires <br />requiring daylight sensing and / or occupancy <br />control > 10 kW. indicate that all automatic <br />lighting control systems are required to be <br />commissioned: or provide building lighting <br />power calculation demonstrating eligibility for <br />exception <br />Indicate Cx requirements in plans and <br />specifications for all applicable electrical and <br />lighting control systems per C408 <br />E Sheets <br />Page 9110 <br />